We recently announced the release of our self-serve virtual assistant. You can read the full announcement here. Videos and documents are available within a click for our latest products. Once you've told the bot what device you're using, the context ...
Forum Posts
(Updated September 2023 - Added Catalyst 1200 and Catalyst 1300 ) Hello! This sticky-post will serve as a sign-post for incoming community members. Below you will find links to pages that you may find helpful. Catalyst 1200 & 1300 Hardware Install...
Resolved! Lag and LACP 20g link possible?
Hi, So I have a stack of sg550x's, and sg350x's as the edge devices. I'm connecting them via lag groups with lacp enabled, and I was hoping to see a 20g link when connecting the 550x to a 350x (ports xg3&4) with 2 fiber connections Is that a thing wi...
In March 2022, it worked. I upgraded three SG350 switches (two non-PoE 24 port and one non-PoE 8 port) by backing up the running config from each SG350 and updating (importing) each into its CBS 350 counterpart (we bought the CBS models based on Cisc...
How hot do these CBS 250 run ? Today it is 100.4°F (38°C) outside and this is what the CBS 250 reports : T inside a cbs 250
HiI'm knew to CISCO hardware so please bear with me (also I'm using the GUI).I'm trying to set up 2 VLANsVLAN1: 192.168.0.0/24 - voiceVLAN2: 10.0.0.0/24 - dataVLAN1 will be connected to a BT router which will act as the DHCP serverVLAN2 will not have...
Hi All I have a SG350 switch that is the main switch in this network 2 Vlans setup (Voice and Data) All device are able to get dhcp as normal The IP Phone as well all get dhcp fine as well The issue is regarding a Snom M300 Base station...
Hi, I'm a little unclear on how essential Probes are with deploying the Cisco Business Dashboard.I have a lot of smaller sites (which is why I am using the SG/CBS series), so I am not keen on deploying a Probe VM at each one, which I then need to mon...
What is the memory utilization command for sg500 switch through CLI
hi,I am unable to find memory utlization for sg 500 switch?please help me for this
I'm trying to set up dot1x on our new Cisco switch. In general a basic setup with RAIUD authentication works fine so a big success on that front (tho I'm still in a generic testing phase).However I wanted to make use of the guest VLAN option to permi...
Hey Guys today I'm gonna show you the way to configure Voice and Data vlan on the same port on Cisco Switch CBS 300 Series. And I have two options to archive this.Scenario:I have created Voice Vlan (VLAN 10) and Data Vlan (VLAN20) and Native Vlan (VL...
Hello, I need to do a firmware upgrade to my SG200 switch. My current version is v 1.1.2.0. It's my understanding that I'll need to upgrade to 1.3.5.58 before going to 1.4.1.03, which should be easy enough. My question is with regard to the order of ...
Hi Gurus, i've a very basic question. How do I know as to what size of network does the CBS-350 4G or 4X series can handle at the access & the collapsed-core?Let take an example of the basic data for the CBS-350-48T-X:800 MHz ARM processor, 512MB of ...
need a newer model from cisco IE-4010-4S24P with the same or additional specs which shouldn't be EOL from cisco also.
I'm a bit of novice at this but wanted some advice before I waste too much time. I have a SG-350-28P and want to set up 2 VLANs. One 'internal network' that uses fixed IPs for each device (10.0.0.XX) plugged into ports 1-14 and then a different net...
Resolved! Cheap Switch,s required
Recommendation required for the Cheap switch,s.
