Switches - Small Business

Hi All   I have a SG350 switch  that is the main switch in this network   2 Vlans setup  (Voice and Data)   All device are able to get dhcp as normal   The IP Phone as well  all get dhcp fine as well   The issue is regarding a Snom M300  Base station...

Hi, I'm a little unclear on how essential Probes are with deploying the Cisco Business Dashboard.I have a lot of smaller sites (which is why I am using the SG/CBS series), so I am not keen on deploying a Probe VM at each one, which I then need to mon...

What is the memory utilization command for sg500 switch through CLI

hi,I am unable to find memory utlization for sg 500 switch?please help me for this 

I'm trying to set up dot1x on our new Cisco switch. In general a basic setup with RAIUD authentication works fine so a big success on that front (tho I'm still in a generic testing phase).However I wanted to make use of the guest VLAN option to permi...

Hey Guys today I'm gonna show you the way to configure Voice and Data vlan on the same port on Cisco Switch CBS 300 Series. And I have two options to archive this.Scenario:I have created Voice Vlan (VLAN 10) and Data Vlan (VLAN20) and Native Vlan (VL...

Hello, I need to do a firmware upgrade to my SG200 switch. My current version is v 1.1.2.0. It's my understanding that I'll need to upgrade to 1.3.5.58 before going to 1.4.1.03, which should be easy enough. My question is with regard to the order of ...

Hi Gurus, i've a very basic question. How do I know as to what size of network does the CBS-350 4G or 4X series can handle at the access & the collapsed-core?Let take an example of the basic data for the CBS-350-48T-X:800 MHz ARM processor, 512MB of ...

need a newer model from cisco IE-4010-4S24P with the same or additional specs which shouldn't be EOL from cisco also.

I'm a bit of novice at this but wanted some advice before I waste too much time.  I have a SG-350-28P and want to set up 2 VLANs.  One 'internal network' that uses fixed IPs for each device (10.0.0.XX) plugged into ports 1-14 and then a different net...

Hi, I'm a beginner using cisco switch for VLANs.I've configured a switch with 4 VLANs for data/AP/CCTV/IP phone VLAN 2,3,4,5when I pull out and reinsert network cables, these ports configured for IP phones turn from access GEs  to the trunk how can I...

I've read and re-read the manual and documentation on my switch and I'm still not getting the answers I need to move forward. Any input would be helpful!!I have a SG500X-24 stackable switch. I'm attempting to connect to our Frontier ISP connection us...

I have problems with double login on Cisco SMB SG220 (IOS version 1.1.4.1 ). There is no option to enable Automatic login in GUI (no option in GUI Security > SSH Server > SSH User Authentication and tick Enable for SSH User Authentication by Password...

I found log from below.19-Jun-2018 03:07:40 :%SECURITYSUITE-I-SECSYNBLOCKED: 03:07:40 19-Jun-2018:A TCP SYN Attack was identified on port Po2.TCP SYN traffic destined to the local system is automatica[0mMore: <space>, Quit: q or CTRL+Z, One line: <re...