Switching

Hi All   We have a remote site that connects back the main site using a gateway to gateway VPN connection, (HQ Cisco 5505) (Remote Site 877 Router) our Mitel phone system is located at our HQ site. At the remote site we have 2 vlans, data and voice ...

Hello everyone, We have 2 cat 6500 in vss mode with 4 VS-S720-10G MSFC3C as sup engine, these are the access switches to our storages. Here there are 2 models of storage attached to the switches in redundant scheme: emc vnx 5500 and emc vnx 5700. Eac...

Hi, from my understanding when the permanent argument is added to a static route, the route will remain in the routing table even if the associated interface connected to the next hop goes down. I've labbed this and it doesn't work. I have to also m...

Hello Everyone My goal is to create an access layer stack of eight 2960x switches (or two stacks of four) but my concern would be the up-link speed to core (4506-E).  A fellow engineer suggested a 10G up-link from the stack.  Is anyone running a sta...

 Suppose The interface 'gi1/0/4' is checked for outbound discarded packets. Please can you tell me what to do , i am facing this problem on interface gi1/0/4(core switch L3 Cisco 3850, cisco WS-C3850-24S) which is connected to Router. Description: ...

I am doing a project for school that requires me to build a parts list.  For now I am concentrating on Building 1 with 140 PC's, 137 VoIP, 27 AP's. For the access switches I've chosen; 1x - Cisco Catalyst 4507R+E - switch – Chassis             4x - ...

HI,    I'm running native vlan(data) currently with default settings in L2 switches and I want to add Voice vlan with the same interface as sub interface ip for data and voice, example, Vlan 1-data---IP 10.0.1.0/24-->on fa 0/0.1 of router sub interf...

First, I apologize for being so inexperienced as to even have to ask a question like this... I have a small medical practice.  I am trying to set up Guest internet access for my patients.  I use these same Access Points for my secure wireless access...

Afternoon all,I've several production Catalyst switches that are listening on the same IPv4 and IPv6 ports. The problem is I don't want the switches listening on the IPv6 ports.OUTPUT FROM SWITCH:switch#sh ip sockProto       Remote     Port     Local...

Hi folks, I'm trying to upload a new IOS to a CISCO ASR 1001 but the FTP session ( via putty) keeps kicking me out after approx 1 hr. The IOS is 400MB in size. I get the error server unexpected closed the network connection. The FTP server is on my w...

Hi, From my understanding, WRED is better than WTD. WRED can avoid discarding big trunk of packets. However, the new switch platforms (3560, 3750, 4948 etc) all support Srr with WTD. Is there any specific reason for srr using WTD instead of WRED? I c...