Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

I have two locations with the following switches:Location 1: (2) 3750-48P in stack, SW version 12.2 (50) SE, IP SERVICES imageLocation 2: (1) 3750-48P, SW version 12.2 (35) SE5, IP BASE imageI need to take a switch from Location 1 and move it to Loca...

dotwell11 by Level 1
  • 723 Views
  • 3 replies
  • 0 Helpful votes

Hi - trying to resolve an issue with multicasting. We have a site that is working fine and we have a site that is not working. We are not sure if the issue is with the router or the host device trying to receive multicast traffic. The configurations ...

Hello Mr. Watts:My name is Tom Jenson, tjenson@gwhf.org ;cell 254-253-1803 and I’m a Network Manager at a small rural Hospital in central Texas. In the past two weeks I switched Internet providers and I just finished upgrading from a bonded-T1 3Mbit ...

tjenson76 by Level 1
  • 1173 Views
  • 0 replies
  • 0 Helpful votes

Hi everyone!I'm trying to check wheather a WS-C2960S-STACK module is working, but I can't connect the two 2960 switches yet.Is there anyway I can find out if the stack module is properly working without actually connecting the switches with the stack...

Hello All,I've been trawling through the forums here and while I've found a lot of good advice, I haven't found anything that makes sense in my case. Here's what I have:Two of our sites are being set up with a PLC network. The vendor has decided that...

HiI need to connect a router to a voice vlan port to allow all voice traffic to exit the VLAN without having to transverse onto the data vlan and use its gateway.However any device I assign to a voice vlan port is ignored by the switch if it isn’t a ...

I have an issue with a 7206vxr that is booting into setup mode because it cannot find a configuration.  The config register is set good at 2102 but it boots into setup mode on restart.  I can put a configuration on it and it will run fine from runnin...

mialbert by Level 1
  • 239 Views
  • 1 replies
  • 0 Helpful votes

Does this exist?Example: "neighbor 1.1.1.1 cost 100"I have a pair of ASA 9.1x firewalls. They are connected to a pair of Cisco IOS routers. One router is the primary path to my MPLS network. The other is a router on my DMVPN backup network. There is ...

hypnotoad by Level 3
  • 741 Views
  • 9 replies
  • 0 Helpful votes

We are in the process of replacing a pair of 6509 chassis with 6509E's until we can replace them with Nexus 7ks next year. In making this change, we are also replacing the SUP 720-3Bs with VSS SUPs for added redundancy.Today these cores have a typica...

campbech1 by Level 1
  • 1257 Views
  • 8 replies
  • 0 Helpful votes

Trying to set Outside inteface to DHCP with commend:ip address outside dhcp setrouteAnd receive this error:DHCP command failedThis problem also during the config factory-default procedure.The Firmware is Cisco PIX Firewall Version 6.3(5)Cisco PIX Dev...