Switching

Hello,We have a 7600rouer.Router#sh ip cache flow | in K ....Vl192            192.104.148.198  Vl192           192.68.181.57   06 E8A5 3E80    10KVl11             119.203.38.35    Vl106            10.202.55.140   06 0050 0EA0    13K--                ...

Hello,I'm trying to enable SNMPv3 on my Nexuss 5548.  On my 2960 and 4900, I was able to use the commands below and snmpv3 works great.  How can I duplicate the configuration on my Nexuss 5548 so that it matches the config on my 2960.  It does not ap...

can any one tellwhat is the diffrence b/w 4510R-E and 4510R+Ewhere the 4510R-E is costlier than 4510+E  and 4510R-E supports only24 GB per line card where as 4510R+E supports 48GBps with sup 7 E

Can someone tell me what tcp normalization is? And how I can tell if it is happening within a data flow? I assume you can see it in a sniffer capture.Thank you

Hi there,After a rocky start with this router with it constantly freezing which required a reset the update the firmware to 1.1.19 the router settled down perfectly without a sinly freeze.  Even though it ran smoothly, I did notice some VPN issues an...

I need to enable jumbo frames on a Nexus 5548. I only need this on four 10G ports for Netapp fillers.Can I enable jumbo frames on only these ports or do I have to do this under the default class? if so will this affect traffic in the default class th...

I have configured a tunnel interface whose tunnel source and  destination are IPv4 addresses. The tunnel mode is the default, 'gre ip'. The tunnel interface has only an IPv6 address. The result should be IPv6 over GRE over IPv4.This all works fine UN...

Hi all,Can anyone tell me how to achieve inter-VLAN routing on a Cisco 887 router without having to connect each of the Fa interfaces to a separate switch port?The manual says to configure VLAN interfaces and assign IP addresses to those interfaces, ...

Hi,I'm considering in replacing a single 6513 chassis that currently is playing the role of the core router switch - all layer 2 and 3 routing happens on this node.  This site is not a high bandwidth data center, it is a branch office and we've outgr...

I have a stack of 4 2960s switches. 2 of the for have no stacking issues. If I remove either the 3rd or 4th switch from the stack (physically remove stacking cables), I get the following when I issue a sho sw cmd: CHEE_MDF_2960S_STACK>sho swSwitch/S...

Hi,I was wondering how can i redirect traffic  for http  from 1841 cisco router to  my External Squid proxy server outside our LAN please?Thanks,jack

I have a user who runs VM on his workstation, and this is the error switch logs: Host 0003.ff88.ea48 in vlan 2 is flapping between port Fa0/7 and port Gi0/1I'm pretty sure it has something to do with that VM.The error is marked as warning, so I don't...