Switching

What is the maximum number of computers that should be put on a single subnet?

hi all ,i'm newbie with vrf and have some questionare vrf supported on Virtual switch 6500 (VSS) ?if yes is there a way to have some traffic "crossing" from one vrf to another (in the same virtual chassis) ?if yes is there a way to apply filter (acl)...

Hi - I am using PRTG to monitor web traffic. I have a 4507 switch. All works fine except the local subnet is not being monitored. What I mean is this - the switch itself is on 192.168.2.0, as is the computer running the PRTG. I can see all other ...

what size of UPS is required to support the power requirements of three 3750 swiths.

Hi,I have two cisco 4507 one will be act as server and one will be client in VTP domain.I want to configure 3/47 and 3/48 member of etherchannel group 1 in switch 1 and same ports on switch 2 will also add in etherchannel group 1 of switch 2.interfac...

Hi, I have a switch 3560 ios, issue is under vlan2 two server are connected with diff. series network say on port 1 -192.168.5.2 n port 2 192.168.4.6 I want both server can access each other. what should I do ?

hiwhat is the default ip address on cisco switch 4500 and cisco router 2600best regardsthaar

We have 3 x c3750g switches cabled together in a stack. They each have the same software versions, and no errors are shown on the CLI (show switch detail command shows all OK, with 1 master switch and two member switches).The problem is that the phys...

Hi,While CISCO2821 is ordered it throws the error to seles WAAS license and software , pls advice.

I have a 2950 I inherited, I Did not know the passwrod so I cleared the flas using the instructions from Cisco. I than proceeded to configure the switch many ways. The first was was using a excel template I found and I was able to connect throught th...

Here's the configuration:interface GigabitEthernet1/23 description test switchport switchport access vlan 140 switchport mode access switchport nonegotiate speed 1000 duplex full no cdp enable spanning-tree portfastThe cable is straight and in good c...

Hi Experts,can anybody explain what is the difference between subnet & maskRouter#sh ip route connected 10.0.x.x/x is variably subnetted, 11 subnets, 5 masksC 10.4.8.24/30 is directly connected, Serial0/0/0:0C 10.4.8.25/32 is directly...

We have a cat express 500g and I have assigned it a 10 dot ip address. Now in the intitial setup when you press the setup button you have to have the computer you are going to use to configure the switch, set up to automatically obtain an IP from the...