Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,I am experiencing an intermittent connectivity issue in an environment with Cisco ASA firewalls in failover mode and Nexus 5K switches configured with vPC. I would appreciate any insights or confirmation of possible root cause scenari...
Hello NSO experts,I’m looking for some architectural advice regarding a performance issue we’re facing with our NSO NAT service.We’ve developed a NAT service that can configure up to 2,000 NAT rules within a single service instance. The design curren...
So, I placed 3 routers in my lab r1--r2--r3. I run area 0 between r1 and r2 and area1 between r2 and r3. And then I advertised similar subnet on ospf on both r1 and r3. What I saw in the routing table amazed me a bit.1.0.0.0/32 is subnetted, 1 subnet...
Hello community.Meraki APs are currently registered in the DN3 inventory.I tried to delete these devices, but the deletion fails with the following message:Device cannot be deleted. The device is either Meraki device or Unified AP, which is unsupport...
Firewall platform CSF 1200 with ASA has opt_cisco_config with increasing size, every week, \opt\cisco\config\var\log\ process_stdout.log increases in size by 910 Kbytes, by about 1 percent each week.process_stdout.log writes every minute one entry, s...
Hello Team,I need help with call blocking configuration in Cisco Unified Communications Manager.We have an IP phone extension (example: 1001), and we want to block incoming calls from specific numbers so that calls from those numbers should not ring ...
Hi All, I am trying to find the best solution to enable a Supervisor to close the contact Center early, by dialing in and adding a PIN. I am struggling to find any documentation. Can anyone point me in the right direction, please?
Hi everyone,We're currently preparing a migration from NSO 6.1 to 6.4, the latest long-lived release.My question is - did the YANG compiler become more strict? If so, is there documentation somewhere that describes the changes?We're recompiling our N...
We are running into this bug on several of our 5108 chassis with the 2408 IOMs. Our fabric interconnects are 6400 series with intersight firmware bundle 4.3(6.250084), which is the recommended version. We are fixing the problem by having Cisco clea...
Hi All,Customer has purchased a few Cisco Smartnets for 9200 switches. These contracts are visible in the Subscriptions and Services URL (https://ccrc.cisco.com/ccwr/)However, there is a new page in the Cisco License Central called "Device Inventory"...
Hi all,Just downloaded SecureClient 5.1.17.3394 and I am having trubles with authentication with certificate after upgrade.After downgrade to previous version I used so far 5.1.16.194 the problem disappeares.The 5.1.17.3394 client getting me message ...
I hope we have soon a feature that lets admins reset an SSID to its default settings with one click. Right now, we have to manually undo every setting, which takes time and can lead to mistakes.Saves Time: Quickly resets an SSID without needing to ch...
Hi allWe have configured SRv6 between a Cisco NCS router and a Huawei router. The peers are communicating over ISIS. BGP peering is established using IPv6 addresses. Under this BGP session, both VPNv4 and VPNv6 address families are enabled.IPv4 route...
