I am implementing a TelePresence soloution for my customer. Can I register an MGCP Gateway with CUCM for audio add in/live desk calls or do I need to use a SIP gateway?
Hello,I'm having some difficulty with dialing conventions in H323 and am hoping to find some assistance.I have a CUBE/Gatekeeper in the DMZ with firewall rules to allow H323 communication w/ the GK. I have internal video endpoints registered to the ...
Hello,thanks for taking a look.....Hookflash for supplimentary services using Application, Service DSAPP is not working...Have 2 problems:1:If I make an outbound call from FXS phone to PSTN I can get secondary dial tone....If I receive call from PST...
Dear Sirs,Our Telepresence solution includes CUCM 7.1, CTMS 1.6, CTM 1.6, CTS-3210 and CTS-1300 Endpoints, Cisco 3945 with MFT-E1 and DSP modules as the PSTN Gateway.We want to use audio add-in function in the solution.Do we need additional equipment...
Hi all,Just a quick one, how do I set a Cisco SD IP Camera Indoor Dome 2420 Series back to factory default settings?I have 4 Cisco cameras setup but for some reason I cannot access the 4th camera.On the router, I can see arp entry but it is incomplet...
I would like to know if is possible to change the language of the Telepresence User interface that appears on IP Phone 7975 used for Telepresence system? The default language is english and a customer asked me about other language options for the 3 b...
Hello,The problem has to do with video Call Admission Control (CAC) between two phones in separate Regions. The goal is to allow one audio-video call, but force the second concurrent call from one 9971 to another 9971 as a audio-only call. I am tryin...
Dear Sirs,our customer have are three CTS-3000, CUCM Cluster, CTS Manager, CTMS.CTS-3000 - Firmware version is 1.4.3.CUCM - Version is 5.1.3.2000-3, hardware is MCS-7825-H3.CTS Manager - Version is 1.3.1.0 (460), hardware is MCS-7835-H2.CTM...
I need a help of this error (20518 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs ) I configured router connected to Ericsson MD110 but the controller e1 is given me that error andif im calling it's telling line busy.
Hi,I have the following setup:CUCM---SIP---CUBE---SIP--ITSPSIP are configured between CUCM-CUBE and CUBE--ITSP SIP server, both CUCM and CUBE are behind corp firewall using private IP addresses, on firewall we have a static mapping to CUBE and we onl...
Hi,When we plug the Cisco IP Phone 7911 to the Catalyst 4506 switch port, the phone seems like cannot register IP address with the Cisco Call Manager. The phone stucks at the "Configuring IP..." message and cannot proceed at all. These issue occu...
HiI have network which everywhere set mls qos trust dscp and quto qos. normally, I setup video conference equipment to se QoS as video AF41,CS4 and voice EF.now, there is one video equipment, it has only one bit for QoS. Could anyone advice me which ...
Hi, I have a SIP trunk working with my 2811 and a few phones for a small office call manager express. The only issue I have is diverting incoming calls on the sip trunk back out on the sip trunk to a mobile number.Internal call forward to external i...
