TelePresence and Video Infrastructure

I what to use a dx80 with a generic sip server

Hello, I have a problem with 2 endpoints on my site. One of them is a Tandberg 6000MXP and the other one is a Cisco SX20. The Tandberg has encryption set to auto with AES-128 and the Cisco SX20 has BestEffort configured. When the endpoints call ea...

Does anyone know if its possible to Disable the LAN port on the ISDN Link? I'm not talking about the companion port for the Codec side. I'm looking to do this through the Serial port. Thanks

i have a customer with a cisco sx10 and i was wondering if anyone can tell me the pin config for the 4 pin mini jack cable thats for the mic  

I'm trying to find out what is the top level part number for LIC-SX80-MS as the customer has already purchased SX80 and now wants to place an order for LIC-SX80-MS which is not a top level part number ? Thanks,

Hi, I'd like to make a carrying case of DX80 and DX70 (with protection cushion). I could find a CAD drawing of the MX series by Cisco web, but that of a DX isn't found. Can I get that somewhere? regards,

Hello,   I am running TMS 15.2.1 w/ PE 1.7.  I have gone through the configuration for conference settings and tried all combinations to get them to extend and it never does.  There are plenty of bridge resources and I even stated to ignore the check...

We have an SX20 registered to a local Call Manager that we use for CMR Hybrid.  Recently we were on a call with no issues, ended the call then tried to start another one shortly after using the same meeting room but got the error "Call cannot be comp...

Hi Team, I have a small Environment (CISCO2911-V/K9 Router (where my CUCM is installed,  WS-C2960+24PC-S and 25 7821 IP Phones) They only do calling and receiving calls, No other fancy feature. I would like to upgrade from CUCM Version 9.2 to CUCM V...

Hi All How do I manually convert a DX80 to Android? I received a new DX80 this week, and it came with the CE firmware rather than Android. Even though I would like to run it on CE, we are currently running CUCM 10.5.1, and from what I read CE for the...

Hi, We've got CMS 2.1.3 (Single box deployment) with CUCM 11.5.1SU2 and expressway 8.9. I am trying to allow outbound calls to be routed from our CMS to CUCM for further processing. There is a secure sip trunk between the 2 and I am able to call fro...

Hi Community, I have an issue here with 1 DX70 and 1 DX80 connected in a virtual room with those settings : Max bandwidth : 1470 kbps Content frame rate : 30 Content resolution : 720p It connect fine with audio and video (720p30) but they can't recei...