TelePresence and Video Infrastructure

VCS x7.2MX200 TC5.1.4We have multiple MX200s in our building which are controlled by a Crestron touchpanel.  We have disconnected the cisco touchpanel from these units.The issue that we are experiencing is when I am on a connected call, I cannot ente...

  We are testing AD sync with TMS- for Movi users In Provoisoing we have a group for AD We see an error  "External source successfully  created Warining   NO USERS FOUND WITH THESE SETTINGS The no users found error is that referring to users within t...

All, Ive been working with my VOIP lab and until recently I have been able to make calls both in and out. Inbound calls still function but outbound calls have stopped. I was working with the router a little last night and I might have broken somethin...

Hello, I just received my replacement C60 codec  and its not outputting any video from the DVI or HDMI out.  Here's what  I've tried: Tried different HDMI and DVI cables Tried different monitors Used the disconnect *#*#01# combinations as well as 02U...

We are currently running early versions of these products and wish to uprade to the latest F9 or as far as hardare will allow.Does anyone know whether this is possible for:MXP 6000 F3.0 PALMXP 990 F2.5MXP 880 F2.3Or are these products end-of-life and...

Hi all.I have the following issue.Whenever I make a sip call from my TelePresence Blade or TX system through my VCS control and Expressway to systems outside my compnay the call is always interworked from SIP to H323 by my VCS control.If I make a sip...

Hi,     I'm trying to set up a 2800 ISR as an H.320 video gateway. The 2800 is registered with H.323 to CM7 and is using an E1 to connect to the PSTN.The idea is that users with VT Advantage as well as a Tandberg VC H323 endpoint can all use the gate...

All,Can someone at Cisco verify that the DVI input on all MXPs is limited to 15fps?Thanks,Justin

Hi Guys,We are currently trying to mark packets with AF41 but it seems like the TX is not marking the packets correct any help will be much apprectiated Hi Piero,We can see your traffic from IP 10.24.2.9 is coming in with incorrect markings, there is...

All, I am novice MCU operator. I received a request to neighbor my VCSE. My problem is that I do not know where to begin or how to do it. Where can I get instructions or directions on doing this?R, Greg Smith