TelePresence and Video Infrastructure

Hi everyone,I have problems with the HDMI port on the EX90, not given image to connect any device (PC, tablet) to generate presentation.The following processes were performed but the problem persists:Reinstall firmware(TC4.2)Factory resetThe problem ...

Dear All,Can I use the Cisco Tandberg ISDN Link with C40 V.C unit using EtherNet Switch in between as in the Attached Draw?ThanksOmar Mahmoud

Hi all,We have upgraded one of our C Series codecs to 5.1.5 and I am having a great deal of trouble with it ever since.Any arrow press on the remote results in what appears to be a "continuous" press of the button.  This same behavior is exhibited wh...

Dear Team,We have activated two ports A&B in the MCU and  have also checked the calls through  two different networks on both thr ports, and the call is getting connected.But now the requirement is that we want the participants to be connected call t...

Hi All, is there a way to access to 8710 blade by telnet/ssh? I couldn't find anything in docs. thanks Alex

Hi,I have a Cisco Sx20 Device along with MS feature, In this i have installed Cisco Jabberclient  in my IPAD2 integerate with CUCM8.6.My query is if i am dialing a point to point, from Sx20 to Ipad2, it was working fine. If i am trying to establish a...

Hi All,I would like to know if there is any chance of deactivating the manual calls of the Endpoints. The aim behind this idea is to force the users to schedule the meetings because we are finding lots of problems when they try to manipulate the endp...

Hi All,A simple query. With Cisco ios NBAR, when we say 'match protocol rtp video' , do we also match the audio embedded in the video stream ? .. or does that audio get matched only with the 'match protocol rtp audio' statement ?Also, is the 'match p...

Hi all,I'm installing 6000MXP, Tandberg Video Switch and two PrecisionHD Camera as this diagramNow I can switch between two cameras. But there's a problem as follows: two cameras can't be controlled via remote control. I don't know why's that.I wonde...

Hello,I'm trying to achieve something very simple: Join an audio call into an existing Telepresence session.Our Telepresence CUCM are in 8.0CTS is 1.7Our VoIP CUCM are in 8.6.2aI have setup a SIP trunk between the TP and VoIP CUCMs and setup all the ...

Hello ,In terms of latency, would we see a higher latency with units coming from overseas? What should we expect, and therefore set our thresholds to?Thank you

Is there any reason the filmstrip would not show up on a 3010 unit while it was in a conference on the 8710 blade with other 1300 and interop devices. Everyone else saw the filmstrip except for the 3010. Is this normal? I was under the impression tha...

I need help.... how can setting sip account for sx20 ( i have to create account too) Thankssssss