Unified Computing System Discussions

Hello,Here is the scenatio I have. Once, I had only local disks in my B22 servers. Those disks were configured for RAID0 (space required). I installed Win 2012 with Hyper-V there. Now, we have the EMC VNX5300 storage. I created new SP which boots Win...

We have a production flexpod environment - AFAIK totally standard design - Dual ASA / Dual 4900 / Dual 5548 / dual N1010 / Dual FI / Dual Netapp / 4 physical hosts.I have been asked to assist as the VM guys were having an issue with assigning ports t...

When trying to connect a vpc from a nexus 5548up to a UCS FI I get this error.  Any suggestions ?(config-if)# sh vpc consistency-parameters vpc 20    Legend:        Type 1 : vPC will be suspended in case of mismatchName                        Type  L...

On a customer's UCS deployment, I saw that the 6248-FI had 4 FC ports for each VSAN (A and B). I see that they are not configured in san-port-channels and wondered why since I believed that would give them load-balancing capability. When I checked th...

Hi Everyone,We received a new C220 M3BE for a new CUCMBE6k (UCM9.1.a) installation. It came with a pre-installed ESXi 5.0.0 on it.Does anyone know what the default login/password is? Tried cisco/cisco, cisco/admin and admin/cisco.

I found the following statement on cisco:http://www.cisco.com/en/US/solutions/collateral/ns340/ns517/ns224/ns944/white_paper_c11-718938_ps10493_Products_White_Paper.htmlQ&A:Q. I noticed that the servers have two SD slots. Does this mean that I can mi...

Hi,We have UCS manager v2.1 with FI 6248 direct FC attached to NetApp with plenty of storage.Per following doc, Lun size for UC apps should be 500GB - 1.5TB and 4 to 8 VMs per Lun.http://docwiki.cisco.com/wiki/UC_Virtualization_Storage_System_Design_...

We are trying to use port 7 on our interconnect as a serverport.I can configure it as a serverport but it will switch over to Trunk and not to Fabric like the others we have set up.This port is in grace period maybe this has something to do with this...

We are implementing a new Cisco UCS system with 4 B-series blades running ESXi 5.0 Update 2. All was good until I tried connecting my new hosts to vCenter (version 5.0 Build 804277). The hosts initially appeared to connect fine. However, after awhile...

Any issues or supportability problems connecting a Cisco UCS FI to a 2960 upstream switch?This will be connected using channeled gig ports with multiple vlans.Thanks!