Is it just me, or is the download site not working for UCS emulator? The URL is http://developer.cisco.com/web/unifiedcomputing/ucsemulatordownload. It asks me to login, then accept terms, and then returns me to an error that the r...
After upgrading to 2.1(1b) I noticed a new entry when creating your dynamic vNIC's/templates (see attached pic). How is this different from the previous implementation of the firmware?Thanks
Setting up a new set of 6248 FIs running 2.1(a) – HA never becomes ready – After some investigation within NXOS mgmt 0 reports as down “link not connected”, even though I am connected on that interface to both FIs and the cluster IP - I have changed ...
Hi, Cisco Experts:Can I have a definitive answer to the following?q1. EMC mentioned that they do not support FC Port Channel & Trunking with regard to our UCS Fabric Interconnects/MDS/VNX5300?Is that any truth in that?We are trying a Cisco UCS soluti...
Hi all,I have a Cisco UCS C210 M2 with an LSI MegaRAID SAS 9260-8i with 8 HDDs connected.I'm having trouble getting the system to boot off the HDDs.I have configured BIOS to use the Onboad SATA Controller in SW RAID mode (this is the only option that...
I believe I know what the issue is, native authentication is pointing to LDAP. However, I need a backdoor before making any changes to assure I am not locked out.
I cannot seem to get VMware ESX 5.0 host to see EMC VNX5300 through UCS FC setup. It does see the EMC storage through iSCSI.This is our setup2 - WS-C3750X-24T-E2 - UCS 6248 UP2 - Cisco UCS Chassis2 - EMC VNX5300 FC - Connects directly to Fabric Inte...
Hi,Is it possible to backup a configuration(All configuration) from a UCSM 2.0 and import it to UCSM 2.1 ?or do I have have to downgrade the firmware to 2.0 so that it will match the source and then import?Jibby
We are looking at upgrading our UCS system from 2.0(1m) to 2.0(5a). We have ESXi hosts that are currently doing iSCSI boot and as such, we have iSCSI vNICs attaching to LUNs on a SAN. We ran the duplicate IQN script and it came back with 4 entries:...
Hi,We are running UCS 1.3 on 6120XP FI, connected to EMC CX4-480, Fabric Switch DS220b with FOS v5.3.0(a).Need to upgrade UCS to 2.1.What is the minimum FOS version on DS220b required to upgrade UCS to 2.1?I dont see DS220b/Brocade 200e switches in a...
Dear forum users,We are planning to install XenServer on our Blade 200 M2.My question:1) During vHBA setting, it was asking what is the Adapter Policy (Linux, SRIOV, Solaris, VMware, VMwarePassThru, Windows, Default). So what is the policy i need to ...
