Voice Systems and Accessories - Small Business

Hello,I currently use SPA942 and SPA303 phones with Asterisk1.8 and FreePBX 2.10. When I perform an attended transfer, I get the following result:A call BB transfer to C and A is put on hold,C accepts the transfer, B complete the transfer,A and C are...

HiI have a cisco spa 3102 and I need to allow to call to numbers with format:9xxxxxxxxI mean, begin with 9 and then eight digits. The documentation says it is as simple as:(9xxxxxxxx)And I set the parameter in:line1-Dial plan : (9xxxxxxxx) pstn line-...

I have simple XML Phone Application:<CiscoIPPhoneExecute>        <ExecuteItem Priority="0" URL="Init:Services" />        <ExecuteItem Priority="1" URL="Key:Settings" />        <ExecuteItem Priority="1" URL="Key:KeyPad1" />        <ExecuteItem Priorit...

I have been searching the Admin PDF for the answer to this question and it hasn't gotten me anywhere. Maybe someone can help me point it out. I am deploying Cisco SPA 508 in a small office, we currently use Metaswitch. Hopefully you can pick up what ...

Hi,I have a customer with a uc560 who wishes to limit certain extensions (not all) to make outgoing calls using numbers in the local directory only. i.e, can dial emergency nad numbers in the local directory only. Other extensions remain able to dail...

We are unable to make outgoing calls from Cisco SPA112, it gives 2 times missed calls to the receiver and then engaged tone.Tried to check by change the telphone & use with other Internet Service Provider, but still the problem persist.Took the unit ...

Hello ,I recently bought a Cisco SPA112 for SIP-PSTN and at the b end we use DIVA card from dialogic for PSTN(Sweden)Things were fine until customers who started using this PSTN line for testing (from Frankfurt ISUP) ,found issues with precharging .I...

Hi Folks,I'm going a little insane here - hoping someone can suggest a fix.We have a few (10 or so) SPA504G phones in our NZ office, talking to a local cloud PABX mob.  When we first set them up, I wasn't keen on statically configuring them all, give...

Trying to set up voicemail message for SPA 303 phone - when I press the mailbox button it says the line is busy and gives a busy signal. Anyone know why this happens?

We are a hosted PBX provider using BroadWorks R17sp4, and we have encountered an issue with the 500S console on 7.5.2b, 7.5.4, and 7.5.5.  On 7.5.1a, when a call is parked to a user, that user's BLF key on the 500S slowly flashes red.  If we upgrade ...

Hi all,I am running on an issue where the SPA112 (and also ran into the same on an SPA122) returns a "486 Busy Here" on the INVITE request even though the line is idle.I tried a soft reboot and even upgraded it to 1.3.2 but still no luck. Nothing muc...

Hi All,This is my first post - so please be gentle!One of the sites I look after uses Allied Telesis switches and routers (and this is what I trained on) with a UC540. I see that the UC540 is attached to the AT8000S switches via the expansion port. C...

I am building a telephony platform for use by a call centre and I have chosen to use a UC 560 FXO Model router for Local call routing and SIP trunk to a GSM gateway for Inbound and outbound calls. Hence my questions:1)Does the UC 560 FXO model router...