Hello guys! When quoting a new BE 6000 for a migration from an existing CallManager version 4 and Unity version 4 can the new BE 6000 be ordered by using CUWL (CMBE6K-UWL) or CUWL is only for existing BE 6000 deployments upgrad...
I have several phones set up in a workplace environment where all phones (508g) monitor the main line appearance. (SLA) So many calls are coming in on this number. When the employee is on the phone, and another call come's in on the main line, a call...
My LinkSys SPA 3102 worked well over 2 yrs Today morning I've discovered it is out of order: Red LED (power) flashing and I can hear modem "tick" 2 secs pause and again After 5 mins everything stops (no led, no ticking) If I power it off / on - still...
Hello all,I don't know about you all. But the CCA has giving me lots of problems. So I got problems that i need to figure out. We have small branch locations that have only about 5 to 20 users at. So we have purchased 3 of these units (3 more o...
Dear support,I'm experiencing an issue with dialplans for brazil, when calling cellphones. A mobile phone number is usually composed by a 8 digits number. Sice 7/31/12 all mobile phone in São Paulo area has changed to 9 digit number, how can I add th...
(A note: I suspect this post may fall outside the bounds of the terms of use. I do however feel our product is of genuine interest to a lot of members of this group.)We offer a reporting and real time statistical package for the UC 500 series.My comp...
Hi I done site -to -site VPN between two UC 560 and I am able to make call too. Both site I am using DDNS FQDN. Now I am facing these problems, 1. When ever any of the site gone down , it is taking around 45 minute to get reconnect the VPN. 2. Wit...
Curious if anyone has the above working and might be able to provide some pointers? Inbound/Outbound calling is fine, and we can call-fwd to internal extensions.When call forwarding to an external number, or setting up SNR the calls just fail (fast ...
Hello,I really can't seem to find anything related to my problem on the web, so I thought I would ask.I have some SPA8800 (firmware 6.1.7(GW)) and an Asterisk box (Asterisk 1.8, FreePBX distro). Everything seemed to work fine while I was testing the ...
Good afternoon,Could somebody tell me if wireless phones 7925 are compatible with uc520? Do I need to have a special version o CME? i've read somewhere that the uc520 also supports the Cisco 521 Wireless Express Access Point. Can somebody tell me if ...
Hi TeamWe have a client with UC320W confirgured with 3 FXO and 4 SPA500 series handsets... The config is1. Whenever their is an inbound call, all the handset ring simultaneously...even if the customer picks up 1 handset, all other show a missed call....
Hi I'm not able to login to BE3K GUI interface anymore with the following error message "The requested resource () is not available" after I completed First Time Setup Wizard. I followed the BE3K administration document on Page 355 - "Troubleshoo...
Good morning all,I've got a seemingly intermittent problem that is driving me nuts trying to track down.UC560 on a PRI. Configured using CCA. Every so often, we get an incoming call who says our main line takes about 10-20 seconds to ring. I've p...
Is it possible to have an extension be able to see night service status, and be able to use the night service code, but NOT receive the bell notifications for incoming calls?Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
