Voice Systems and Accessories - Small Business

Hello,I recently replaced our old PBX with a brand new and shiny UC560.The setup:We have 4 SPA525G2 and about 14 7960s phones.The UC560 is directly connected to a SG300-24p switch, which again connects two SG300-10p switches on other floors. The swit...

I've just connected a 2n Helios Doorphone - how do I add this sip device to the UC320 ? 

Hi,I have been having issues with routers and ADSL Modems for some time with the UC320,Some of which I have TriedDraytek VIgor 120Draytek Vigor 2600Zyxel P660Netgear DS834Gv3, DS834Gv4, DS834Gv5Linksys WAG354GOnly some of which I have tried, but all ...

SPA122 running Beta FW 1.2.0 (Although this bug is present all the way back to 1.0.1)Start with a completely defaulted ATA. Configure proxy address, sip user, and sip password.Originate a call from the FXS port. After call is answered by far end, dia...

Tengo DOS spa3102, uno configurado como FXO y otro configurado como FXS sobre un enlace satelital, lo que resulta es que cuando hago las pruebas de laboratorio, en una misma red local o en una red que no es la satelital anda todo bien es decir tomo t...

I am deploying a VoIP solution and I need to link the internal IP phones to a PSTN line. SPA8800 would be a perfect candidate for this.However, I need the gateway to NOT pick up the line until an internal IP phone has answered the call, both because ...

HI, I had configured UC560 via Telephony configuration wizard in CCA and I assigned PPPoE configuration too. After saving the configuration I was able to get the internet connection from UC.But after a day I removed the Dialer0 interface cable  and r...

Hi,I would like to know the progress of Standard SRTP (SDES)  support in SPA3102. With users growing concern over pircary and VoIP being used as a replacement for the traditional PSTN networks, it would be great if SPA3102 supports the standard Secur...

Device: Cisco/SPA508GOld Firmware: 7.4.8a, SIP Capture File NOTIFY-GOOD.capFrame 18: REFER (Supervised transfer) received by phoneFrame 19: INVITE w/ Replaces - New call, that is result of REFERFrame 22: Response 183 for the new callFrame 23: NOTIFY ...

If a customer is using telco-based voicemail can I get the MWI to light up on a 7960?  I've searched the web and heard of MWI working for Vonage but not telco-based voicemail on POTS.  ThanksPaul