Voice Systems and Accessories - Small Business

Just configured an SPA 3102 Device with Asterisk 1.8.Outgoing calls works fine, but I have a question:Every time I dial from Asterisk to PSTN, In Asterisk I send all digits to SPA 3102, when I press dialInmediatly I see Call Connected, and start hear...

My newly acquired SPA8000 loses  the newly updated system time if I shutdown the unit  by removing power. It resorts back to 2003 12:00.is this normal? seems bazaar that I have to update the system time under regional tab.Also is there a way of backi...

I can't send/recev fax T38My schema SPA 2102 register on CUCM as standart sip device. T try send fax to H323 gateway  Cisco 2821 (fxs port).Then I call i hear fax tone 1 sec and call end with error in SPA debugAll in my local LANConfdial-peer voice 1...

A UC500 running uc500-advipservicesk9-mz.124-11.XW7 and Cisco Unity Express 7.0.3.  When calling into the AA, from internal or external, when you dial an extension or choose an option to be transferred to an extension the caller gets only dead air un...

I am transitioning from a SPA9000 to a UC520.  I am trying to still use my SPA VoIP phones,  I realize I can't use the Cisco Configuration Assistant to set them up, back I can manually via browser or front panel.  I don't see in the running config on...

Hi,I have a client who has 6 sites which are all connected via Point-to-Point T1's.  Each site has a 1821 router that terminates the point-to-point T1.  Each site needs about 5 phones.  I was thinking of putting a UC560 at the main and having the rem...

How can configure UC 560 in this way:Now we have when outside caller call our company number (receptionist) and if she busy or not at her desk phone call goes to another colleague (it should work on this way.) But we want when inside caller call the ...

UC 540 has one FXO and one SIP trunk. Incoming calls on FXO are pointed to AA extension 500. If you press 4 during AA, it is supposed to use SIP trunk to dial external cell phone. External call transfer is enabled and 9 prefix is configured before ce...

Hello Community.I have a customer using a UC560, 16 local phones, 2 remote.Their AA currently routes callers to Hunt Groups for sales, purchasing, etc... via "press 1 for sales"...They would like to do this: (Names have been cahnges to protect the in...

Hey guys,Has anybody configured an SR520 as a remote teleworker lately (with CCA 2.2.4)?  I've tried two SR520s now and neither of them are working properly.  I can create a VPN using the Cisco VPN client software from the same connection (even throu...

We have a UC-540 at the gateway of our network (performing routing, NAT, QOS, DHCP, etc).  Every time we have to reboot the UC-540 (or it reboots itself) we not only cant surf, but cant call wither.We are considering placing a 4-port Cisco 520 Secure...