Voice Systems and Accessories - Small Business

Configuration:1) SPA90001) SPA400 with 3 analog lines1) SPA400 for Voice Mail3) SPA508G PhonesI'm having a strange problem with my AA - I want all phones to ring several times before transferring to the AA. In the Setup Wizard I've selected: Ring ext...

From my partner:"We want to use our Blackberry MDS with the UC560For the UC560 can we use our Blackberry and then from the Blackerry can we then transfer to another extension?"Thanks - Art

We just recently rolled out a UC560 with CME 8.0/CUE 7.1.3/IOS 15.0(1)XA Release fc2.  We have 48 users with combination of 7942 and 7962 phones.  At present, we are experiencing intermittent fast/busy tone when dialing out and it happens only very s...

Dear SBCS Community,As we approach the release  date for the second beta drop of Cisco Office Manager  (http://www.cisco.com/go/officemanager), we would like to recruit 8 end  users that are familiar with our UC500 product and use it on a  daily basi...

Hi all,I have been trying to get FAX configured for our UC520Fax to email is just not working for me so I would not like to redirect the FAX communication to our office FAX machine. This machine has an private IP address 192.x.x.45I have onramp confi...

i have a uc 520  for which i upgraded the ios and cue and of course when the upgrade using cca 2.2.2 completed and the uc 520 rebooted the ios was corrupt. so i opened a tac case to get help reloading the ios. the guy helping upload said that i would...

I have 2 separate subnets on the network. One for the PC's and one for our VOIP equipment. I have, with other hardware, been able to connect to a wireless AP with a static IP on the VOIP subnet and been able to use it just fine.The WIP310 refuses to ...

SPA8800 does not pass the call from PSTN port(line 1) to VOIP port(phone 1).If caller called on PSTN line its keep ringing, not forwarded to VOIP port(phone 1).For eg; SPA3102 pass the PSTN call to VOIP port(Phone 1).NO settings found in SPA 8800:  P...

Quick question regarding the phone display on the 7942.  In the upper right-hand corner the user's name is displayed.  Can this be configured through CLI or does it need to be done via CCA?Thanks in advance for the help.Jeff

In case of a sitation where a customer have around 70 users disctributed over 4 sites connected via ADSL Connections, can we position UC500 Solution where UC560 will be located in the main site & other sites are using this centralized system? or we h...

Maybe I am being lazy, ignorant, or a little of both. I admit that I do not spend much time in CCA configuring our boxes, but spend most of my time designing and working in cli or cue gui.  So here goes:1. How do I build intercom extensions via CCA? ...