Hi, I'm moving my IPSec VPN's from my Cisco Concentrator to my ASA 5520. I log (to a syslog server) users that logon and logoff, how can I do this on the ASA?
Hello everybody,I have an ACS appliance 1111 installed on HP server. It's installed and I have to CD to make a recovery.The server starts until arrive at the page where say that ACS i running and you can access via Serial or Browser.I havn't the IP a...
Hi!I have a quick question. I like to set up an IPSec VPN which terminates on a c871. The C871 is hooked up to the internet but gets a new IP from the ISP every 24hours. Is it possible to run an Endpoint on the box if the WAN-IP changes frequently? D...
I have a failing 1720 router that is the center-point to a vpn with two dynamic 1720 routers connecting to it. It also is supporting PPTP VPN connections but I am planning on replacing those with Cisco VPN Software clients. My problem is with the t...
Hello,One of our customers so far operates a Cisco VPN-Concetrator 3000 together with a RSA Authentication Manager in order to authenticate the VPN users.Upon a VPN or RAS user authentication request from the VPN-Conc the request is forwared to the R...
Hello Guys,I am experiencing a problem with Site to Site VPN between 2 ASA/s 5505. It seems very simple task, and it is, but I am missing something. I just want the communication between both Internal LAN/s connected on both devices to be UP. I see t...
I have a site to site VPN (between two ASA's)which works just fine, however we want to have control on:1) the ability for bring up the VPN tunnel if only one site initiates traffic. If that site does not initiate traffic the tunnel should not come u...
We have an 1841 in which we are trying to setup both authenticated dial-up (dynamic) and 1 site-to-site (static) vpn connections.I was told by our provider this a limitation of the IOS software and we need individual routers to perform each vpn??Is t...
Hi, I keep getting these errors on my IPSec output, what does it mean and does the other parts look ok?mtree says we have SA but couldn't find current outbound SA. dropping pak. pak->cryptoflags=0x820This is on a Cisco 877 DSL router that I'm trying ...
I have 2 Cisco 857w's currently running a basic Site to Site VPN configured successfully through SDM.Site 1 LAN = 10.10.10.0 /24Site 2 LAN = 10.10.20.0 /24The client would now like all users to access the Internet only through Site 2's Internet conne...
My key server 1 has the high priority than key server 2 in the redundancy configuration for Groups.All group members showing both key server informations in GDOI .But when the key server 1 fails the connectivity drops and showing no policy and acl in...
Hi, I just purchased a 1801W-AG-B/K9 with Advanced IP Services (running IOS Vers 12.4(11)/XW5, image c180x-advipservicesk9-mz.124-11.XW5.bin). I'd like to setup SSL VPN, but it seems per SDM that I must install two additional packages: Cisco SSL VP...
Hi, I tried to configure svc on a IOS box(12.4(6)T5) with split tunneling and loopback interface.The address pool is from the same subnet(RFC1918) as the loopback interface.Apparently everything is ok, the ssl vpn client is downloaded, the connection...
Hi all,Is it possible to establish a site to site VPN connection with one site Fixed Ip address and the other site Dynamic Ip.One site is Pix and the other is ADSLThanksSudeesh
