Wireless

Hi There, We have a simple Wireless setup where we have around 20 sites with around 10 APs at each site and a single WLC 5508 at one DC. I would like to provide a High Availability to the existing WLC over the WAN by placing the new WLC 5508 at anoth...

Hi,I would like to know what are the  main and best Quality  KPIs for wifi (AP,etc.) ,streaming and Digital signage .Anybody any suggestion will much apreciate..Thanks

Hello can the 5508-12 be converted into a standby HA controller? Cisco is abiguously saying that 50 permanent licenses are needed on a standby controller.Does it mean we need 50 base licences (so only 5508-50 and above) or 50 licenses as any combinat...

I am completely new to using Cicsco Aironet products, we deploy 2-3 of these products per site 12 sites and counting. I noticed there is a config file I can download on Aironets that are already setup at sites, they are different models 1100, 1200 et...

To use Cisco Access points 1702i in an Warehouse environment, would like to understand on how many suggested/recommended concurrent sessions can  one 1702 AP can handle?

Hi Everybody            I have an problem about 1 Cisco Access Point didn't join Wireless Controller. I try to plug console on Access point but it Show error like            " * onenand_16x_read_sector failure sector: 0x00000040, spare: 0x00000047Fla...

Hi , Can you explain 802.1x +WPA2 authentication method step by step and WEB authentication step please . And is web authenticaion trust ? Thanks

Hello,We have WLC anchor at main site DMZ zone having an EoIP tunnel with remote site WLC over the WAN network. DHCP server is in the main site which is used by all the remote site WiFi Clients via EoIP tunnel over the WAN.Would the DHCP packets from...

Can we use 7921g wireless ip phone with AIR-CAP1602E-N-K9  Access Point ?

I have experienced that client get wrong ip when connect to wirelessi have 2 wireless profile 1. internal wlan and guest when client connect to guest they get correct ip but when connect to internal wlan client also get "guest" IPso i have attached m...

Hi all, I have a question about N+1 2504 failover testI Already config Primary and Secondary WLC. I test by shutdown the switch interface that connect to primary WLC, after that all AP can register with secondary WLC but when I tried to connect my La...