Wireless

Hi, I need to backup my current config on my WLC 4400.  I want to use TFTP to do so.  However the TFTP server for MAC requires that I enter the name of the configuration file in my TFTP server BEFORE I actually download and save the config.  But I do...

Good evening,We presently have some minimum data rates setup for our 802.11 deployment (.11b/g disabled below 9Mbps, required at 11Mbps and supported at 12Mbps+ and for .11a/n/ac  below 12Mbps disabled, 12Mbps required 12+Mbps supported).  Currently ...

I have new 2504 WLC + 1041LAP. I configured the first DHCP scope on WLC and the first WLAN. Then I set WLC DHCP server in WLAN properties and tried to connect to WLAN with wireless clients.My wireless clients are able to authenticate on WLAN, but not...

I've read somewhere that AP's will retain previously joined WLC IP addresses in NVRAM.  During reboots, it can use these IP's in addition to the ones learned from the typical WLC learning logic.  Wondering if there is any way to view an AP's list of ...

I've enabled option 82 on the WLC, but when I watch clients pull DHCP the 82 option isn't showing up in wireshark. Any Thoughts?  Thanks,   Skymeat

Does phase reversal in the 5GHz band play a significant role at sites where the presence of WiFi inverted interferers is detected by Cleanair? I have a site experiencing some WiFi inverted interference and we can't seem to track down the source. Just...

Hi guys, I've configured a brand new 2504 wlc to replace an older model and it's working fine, but some of the hosts are facing problems while trying to connect. They do all the authentication process, but at the end they don't get an IP. I've checke...

How do you config AP's to roam to the strongest signal without using WDS?I have 3 AP's in a warehouse, 2 - WAP321, 1 - WAP371. No domain services available, they are just standalone AP's with local SSID and key for authentication.They have same SSID ...

All: I'm working on a solution for someone who already has a Cisco WLC 2504 running 7.6.100 and 2602i APs.  They are running iPhones with a SIP application instead of purchasing Cisco 7925G phones.  They are having issues when roaming to different AP...

here is an a demonstration of how to configure vlans and ssid on a auto-ap , what i dont understand is when i configure the ssid under (interface dot11radio0) and the vlan under that command , why do i need to configure sub-interfaces for the "fastet...

I want to deploy APs in remote locations using FlexConnect. I will give the APs static IPs on the local LANS, but I want the clients to get DHCP from the existing WLAN back at the central site. Not sure what needs to be set on the WLAN for FlexConnec...