Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi.We have one customer who have deployed a unified wireless solution using WLC4402. They implemented high security that they have disabled telnet, http & https connectivity to the WLC. Now, configuration changes needs to be done on the WLC but unfor...

tapanglf by • Community Member
  • 7562 Views
  • 9 replies
  • 0 Helpful votes

Hello,We have deployed LAP 1242 APs with one antenna connected to the right hand side antenna connector and the left one is not terminated. The APs are separated 2 inches vertically and 7 inches horizontally. The controllers are configure for auto po...

bghobadi2 by • Level 1
  • 934 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Guest WLAN

Hi,i m in trouble to configure guest WLAN in WLC 4402.i have created 2 WLAN and 1 GUEST LAN and configured correctly.but i m not getting SSID advertisement for GUEST LAN in wireless network when i search available SSIDs.i have mapped GUEST LAN with t...

Hi All, I would like to enable HTTPS access for my access points. It can be done with ip http secure-server. Along with the same I would like to enable accounting for the https access. Is there any way for the sameThanksNikhiL

I have a very small branch office, with a single cisco AIR-AP1231G-A-K9 running IOS 12.3.8 JA. I would like to have them authticate using WPA-PSK and lock them down by mac-address without getting *eap/RADIUS involved. I have it configured however whe...

jtrumbell by • Level 1
  • 2226 Views
  • 2 replies
  • 0 Helpful votes

Resolved! WLC vs WCS version

Hi guys,can i use version 5.2.178 on my controller and 4.2.110 on my wcs?Better:have WLC and WCS to run the same main version (4.2 and 4.2,5.2 and 5.2) or are the wlc and wcs version not related?(5.2 and 4.2)thx...

I have a AIR-AP1230B-E-K9 access point, which worked fine in its original hardware configuration, which included an AIR-MP20B mini-PCI radio module (802.11b standard).I decided I wanted to upgrade it to be a dual wireless, 2.4Ghz and 5Ghz access poin...

domwilko1 by • Level 1
  • 1976 Views
  • 7 replies
  • 0 Helpful votes

Hello AllMy working AP1200 crashed in the bottom I am seeing the lights for radioand ethernet red and status is light purple on the other hand in console mode I am just seeing ap:and possible commands are ? -- Present list of available commands arp -...

ergonullu by • Level 3
  • 1531 Views
  • 4 replies
  • 0 Helpful votes

I am trying to Power a Cisco 521 AP from a blade on a 4500 switch. The blade module number is WS-X4548-GB-RJ45V. This is supposed to be a POE blade, but when I plug the AP in, I do not get the AP to power up.

Review Cisco Networking for a $25 gift card