Wireless

hi, i hv a wireless IP phone,AP, 2960 switch1 and another 2960 switch2. My question is, if i configured voice vlans on th access ports on th switch1 (for voice and data), this switch1 is connected to the AP and the IP phone gets connected to the AP ...

When i try to configure WLSE thru http access. It says WLSE is currently loading information. You will automatically be logged on when loading is complete and gets stuck there not proceeding what could be the problem. I tried to update the software t...

We are trying to get wireless working using Active Directory. It works using the CiscoSecure local DB for users but it won't when it's pointed to AD. We have the AD set up best to out knowledge but still get an "Internal Error" in the ACS logs. An...

As stated above i have a 4400 wireless controller and a air-lap1242AG-A-k9 access point. I have the wireless controller all setup and it seems the LAP ap can not find the wireless controller. i do a Lwapp debug and it scrolls Could not discover any...

I just installed WCS 4.1 and have a test rouge AP. I've been doing some testing with containment, but somehow deleted the rouge AP alert in WCS. I see the rouge AP in WLC, but it's not showing up in WCS. How do I get the rouge AP to reappear in WC...

cisco 1100 software was be disabled,and hardware down. But i can telnet 10.0.0.1, How to sovle it? To enable the dot11radio.

All, I'm in Iraq and I was using the "B" side on at 3 miles away with a solid dish "AIR-ANT3338" and was getting 2meg down on by bandwidth and now I'm lucky to get 400K. I have one root hub and 4 non root hubs linking to it with no more than 6 use...

hallo i have version 3.2.78 on my wlc 4402 and i want to configure it for EAP-TLS. it should be secured by 802.1x and wpa2 but i dont know how to do it properly over the webinterface. every suggestion is appreciated.

Hello,recently I've installed a Cisco WCS server.In the MAPS section I have added a map (outdoor area) and I have dragged the two access point in the map(1 RAP and one MAP) to see the heat map of the signal.The problem is that for the first 2 days it...

All,I have WiSM rev 4.1.185.0. I try to make some WGBs using LEAP and TKIP together with a client username and password. However, no matter what I do the WGB cannot associate.The documentation I found on this only goes as far as wep, no TKIP/AES and ...

We have an issue with a Fujitsu Siemens Amilo Laptop. It uses 802.1x with dynamic WEP and PEAP-MSCHAP (MS-IAS), Verisign Imported Certificate. It works fine in a Autonomous environment but fails in Unified environment. Other laptops work fine in both...

Hi, I am implementing dot1x with PEAP for wire and wireless access, before I get CA running, I am using ACS server self-signed certificate. However, XP client won't be able to authenticate if I have the "validate server certificate" box checked. I di...

Hi, are these AP ready for sale now, cause I do not find them in the ordering tool?For them to work with 802.11g standard, should I configure the same antenna types used for 1200 series, and is it necessary to place the 6 antennas?