Wireless

I have a prototype wireless lan in place using WDS, LEAP,TKIP, MIC and key rotation. I'm using a combination of Centrino enabled laptops along with some Cisco 350 PCMCIA laptops. I am also authenticating to a TACACS+ 3.3 server. We now want to use th...

I have a question regarding best practice recommendations for Cisco Wireless concerning Clients...I have Cisco 1200 Series AP's with IOS Version 12.2(13)JA4. Currently I have Administrators authenticaing for Admin Access via TACACS+, for both http an...

OK, I am stuck.Have an Ap1210 that I need to have at least 2 secured vlans running on. I have configured the ssid's and associated them with individual vlans. Also have the bridge-groups defined and the associated sub-interfaces on the Radio and Fast...

Hi,I'm having a problem achieving good performance on a Cisco 1200 AP [802.11b] which supports about 15 clients. It's been configured to allow only 11MB & 5.5MB access with static WEP & w/o SSID broadcast. But somehow the performance is way below sat...

How many ip wireless phones support Access Point?

Hello group,I have wireless bridge 350 and omni antenna--AIR-ANT24120( 2.4 GHz,12 dBi Omni Mast Mt. Antenna w/RP-TNC Connector). I want to know:1. How many low loss cables do I need between bridge and antenna for each bridge?(one or two)2. How many l...

Hello, Can anybody tell me that the Cisco Aironet 350 Series Access Points can support how many clients at one time?Thank you.

HI, If i have a AP 1100 or 1200 working with 802.11g, can i work with 802.11b clients ? Can someone please help me ??Best regards, Luis.

When doing testing yesterday in the a new floor in a building, I changed the channel of the AP from 1 to 11 due to the fact that there were a couple of other devices I was seeing on channel 1 with the AirMagnet software. I immediately noticed that my...

Hi,about 802.1X protocol I've read " The authentication server may use the Remote Authentication Dial-In User Service (Radius server) although 802.1X does not specify it."Is it possible authenticate the supplier without using an external Radius Serve...

HI, I´m new to WLSE. My AP´s are already discovered and managed, but when I try to download the configuration archive from them, the Job Always fail with a SNMP timeout error message. This problem occur in the upgrade firmware job too.Whe I go to rep...

I found this in the WLSE 2.9 documentation:"Note Only routers and switches that have properly configured access points or bridges attached to them will be discovered"How does this help me when doing rouge suppression? If a user attached a rough AP to...