Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, October 14, 2024 through Friday, October 28, 2024. Our colleagues Saikat Nandy, Parithosh Vema and Naveen Kumar will be waiting ...
Forum Posts
I currenly have the WLC setup on our switches for our network and it's working fine for the laptops and other wireless devices. We just got a new Cisco phone system put in which replaced the outdated Cisco phone system. Along with that we also have t...
What is the latest stable firmware version of air-ct5520-k9 WLC. Currently 8.5.131.0 is running. Should I need to upgrade? Thanks
Good Day, I have a client with WLC: AIR-CT5508-K9ver: 8.5.161.0The Guest portal does not open in MS Edge & Google Chrome - however it does open in "older" Internet Explorer. Any ideas
currently running port security in AP's operating in local mode..the requirement is to move AP into Flex mode and change to Trunk on SW port to allow local vlan swithing for Corp .1x SSID; remaining SSID's will stay centrally switched. If AP is chan...
We looked at it (802.11r) when we first deployed the 9800s on our network but took a pass pass based on the sheer size and the fact that we have no control over the devices students add to our network. We are thinking of evaluating it again to potent...
Resolved! primary WLC
i have to wlc at my company but i don't know witch one is the primary WLCcan you help with commands to check that. thanks
We have 10 Yoto Players and about half of them will not connect to the preferred SSID. Through testing I found that it would connect to one specific SSID. I created a test SSID and applied it to the same WLC interface that mysteriously worked and I...
Resolved! Disabling 2.4Ghz Band
Hello, I have been seeing several rogue devices which use the 1,6, and 11 channels. We have several end-users who experience intermittent disconnectivity issues. I am thinking of disabling the 2.4GHz band and just having the 5GHz band. Is it a good...
We've purchased 3 Cisco Aironet 1830 Series a/g/n/ac Access Points but without Mobility Express. Is mobility express a separate purchase or can this be added with no cost? Or, is there free controller software that can be downloaded and installed o...
Hi,I just noticed that on my 5520 running code 8.10.130.0 when i try to create an snmp community with 7 characters it gives me an error "Community name length must be between 8 to 32 characters.". I do not see this request on this version documentati...
endpoint : Macbook (version 11 and above)SSID security : PSK+WPA2channel width : 40mhz band: 5ghzissue reported :1. while roaming user face latency Observation on Dashboard:1. channel utilization goes high (above 55% )2. latency shown in user perfor...
Resolved! APs and SSH
On my Flex connect setup (9800 LC WLC and 9120AXI-B AP running 17.3.3.26), I have 1 jointed AP, and in the AP Join profile it shows SSH and Telnet enabled and checked. I can ping but no SSH or Telnet. The AP is registered and joined. Accepts clients,...
Hello Friends, i hope you all are very well. I´m having troubles with the RMI+RP configuration on a C9800-L-C-K9 cluster, configured the following parameters: CHASSIS_HA_LOCAL_IP = 169.254.119.205CHASSIS_HA_REMOTE_IP = 169.254.119.206CHASSIS_HA_LOCAL...
Resolved! Problem Client not connected internet
I'm having a problem with the WLC AIR-CT3504-K9, where the client gets an IP address but no internet access. The client can get internet access when the AP is restarted, how do you handle it so that the client connects to the Internet without the AP ...
I am working on a new 5520 WLC running 8.3.143.0 code. We have a WLAN using Layer 3 Passthrough for security. From my understanding, to avoid a certificate error on the browser of an end user, you could generate and upload a 3rd party certificate o...
