Wireless

Dear Sir,Where can I download the VxWorks software which has the version of 11.50T? I cant locate it in Cisco website.Thank you.Delon

I have a hop installed with 2 1410s and about 120 pcs at the nonroot end. This is a very short path about 1000 ft. Will I be ok using 2 28 dbi 2ft dishes pointed at each other as far as too much signal is concerned. I have power set to minimum on bot...

Hi, does anyone know what it means the following WGB error:E Radio Error: 11 Queue full discardsE Radio Error: 9 Queue full discardsE Radio Error: 7 Queue full discardsE Radio Error: 6 Queue full discardsAfter this error WGB lost connection with Brid...

Today, (Sep 1) the WiFi Alliance gave it press release for WPA2. Them gave mention that Cisco 1200 Series Access Points with integrated 802.11a and 802.11g radios will have wpa2 support. Does that include the 802.11b only Access Points?Also, what cod...

Weird situation I have here. This is a testbed wireless network we have up and running before we start rolling it out on a wider scale, so trying to iron out all the little problems.This morning one of our boxes just up and stopped dhcping, no change...

We have several apple users and pc users so I want to find out what the better security solution will be for our wireless.Currently we run LEAP and MAC authentication. I also use TKIP and CKIP. We have ACS for radius.Would PEAP be better? And should ...

The 1310 supports 255 clients in Workgroup bridge mode. Can some of those clients be wireless clients on a 1230 AP with the 1310 registered to a different 1230 AP? Would the clients still be able to roam without problems?

Hello,i only have the possibility of telnet to configure a ap1231g acceesspoint.Now i have to check the mac-filter configuration because it doesnt work properly.How can i configure the mac filter over telnet?I was not able to find a configuration exa...

What is the max length of a shared key?

Anyone have any experience with Netstumbler and Ethereal? I have 6 Cisco 350 AP-350's with 30 to40 PCMCIA & PCI cards active. I have a wireless device with a mac of:DA001D02B403 showing up on netstumbler, but i am unable to get enough info to trace i...

Hey, I decided to upgrade the ios on my AP1231 802.11GThe new ios was too big so I had to erase the older one to fit the new tar file on there. Now it only boots to AP:ap: dir flash:Directory of flash:/3 -rwx 4109312 c1200-k9w7-tar.122-15.JA4 -rwx 22...

Dose anybody know what kind of connector(to antenna) ARLAN 640-2400 has? ARLAN 640-2400 is old Aironet gear(before Cisco acquired Aironet)

I am upgrading some Cisco 1200 802.11g APs from (15)JA to (15)XR1 IOS versions. The config has multiple SSID/VLANs. With the new (15)XR1, WLAN clients are able to associate to the AP fine (back to CiscoACS) but they do not get an IP address. I duplic...

hi folks, I am about to set up a wireless network for our library users that come in from the public and bring their own laptops. We would like to have two options:1) they can open their laptop and just jump on without any authentication. but this tr...

WLSE type: 1105, version 2.7Aironet 1100 devices (267 pieces), IOS 12.2(13)JA4After the upgrade from version 2.6 to 2.7 we have a problem with the WLSE. Device discoveries and inventories run without a problem, but whenever a device goes down the WLS...