Cisco Catalyst Center

I was notified from Cisco that my C9300 DNA Essentials is about to expire. Product number C9300-DNA-E-48=.We're a small shop, and if I recall correctly, we were required to purchase DNA with the switch as a mandated SKU. If I understand correctly, "D...

Been struggling with DNAC compliance reporting with ACLs. I have a basic sample ACL that deploys successfully but the compliance in DNAC flags the entire ACL ac non-compliant. I can see the ACL in the config on the switch and in the configuration in ...

our DNAC_Aura reports 2 Catalyst 9k switches in Bundle mode. Any tips to find which of these 9K switchs are in bundle mode using Cisco DNA ?

Hey everyone, So I've run into a scenario I've not encountered before with a DNA Centre appliance. The customer wants to move it from one DC to another which means we have to change its IP Address, now I'm familiar with changing the IP through Maglev...

I was tasked with configuring Dynamic Address Resolution Protocol (ARP) Inspection (DAI) for user VLANS.  As I was adding the VLANs and enabling DAI my switch suddenly reboot.  I was able to recover so I thought it must have been a fluke- so I tried ...

Hi,Is there anyone encounter issue when do Cat9k IOS patching to version 17.09.05. Before start proceed with Software Update, there is readiness check result need to be done/pass. What we had encounter is the readiness check failed at stage "Flash ch...

Hi Team,Now I'm currently following CISCO CCNA 200-301 certification, I do have "CCNA 200-301 Official Cert Guide Volume 1" & "CCNA 200-301 Official Cert Guide Volume 2" which is published Dec 22, 2019.But i saw some new edition's books are published...

We are having an issue with upgrading devices on external subnets outside our internal network.We have been able to manage the devices via SSH and SNMP via the external address of the switch, although when using SCP to upgrade the IOS via DNA/Catalys...

Hi,I am trying to download the software for our C9606R switch, since we have already used the following release(Release Cupertino-17.9.5 ) on our 9000 series switches, so I am trying to find the same release for the C9606R switch. Now I can only see ...

Hi All, I have an issue with one of my 9300 switches in DNAC. I have added 51 switches in total, but 1 of the switches has an issue when assigning it to a site. The switch has been assigned to a site before, but after deleting it, and re-discovering ...

Anyone been in the situation where an existing switch/stack of 2 * C9300 was onboarded in DNAC/CCC but at some point in time the stack is reduced to 1 switch and the other switch needs to be re-onboarded because it will server in another building. (b...

We have some concerns about the Hierarchy in combination with the Global or Site Local Network Settings and Network Profiles in Catalyst Center. We have a few sites with different AP-Groups (AirOS WLC) configured on APs within the same floor. Our pla...

Have issue when connection between switches.3172pq to c9500-48Y4C.  The interface is set to 10GB at the 3172 with 1000baseSX, GLC-SX-MMD SFP at each each. The c9500-48Y4C does not have speed setting.  Get a speed mismatch error. Any help is appreciat...

Bit of a strange one!Looking at Physical Neighbor topology of an AP in DNAC, it reports the connection from switch to AP as down.  Switch "OB" interface indicates that G1/0/22 is down:However, I know that the AP is online and connected - but it's con...

Does breaking the PnP agent discovery on switch boot up still allow it to be Day-0 provisioned via Catalyst Centre after applying some manual config to the switch via console CLI to be able to reach the appliance controller?The reason being that we a...