IP Telephony and Phones

Hello,I am experiancing a problem that, in my Cisco 7960 Model phone 3 lines Configured and at one of the line call getting answered automatically, can any one having the solution for this.Regards,Madhusudhana Rao

HelloPlease find the attached, Is it possible for  lower standard to borrow from higher standard,i mean to say can Enhanced count can borrow from CUWL Standard count license , What can be done to get rid of the insufficient error.

HiI am currently integrating Lync 2010 and CUCM 4.2 (yes i know its old). Currently the pstn provider has implemented such that they will block any calls NOT originating from the DID range assigned to the company.Have an issue with the following call...

What is default duplex and port setting of cisco 7937 phonePlease send me documentes or related cisco linkThanks in Adavance

Hello,I have Call Manager 7.1(5)   using a SIP trunk to a 2811 talking to a 3rd party PBX using a SIP trunk to the same 2811.  Routing the calls through dial peers.  Works fine except for Caller ID Name.   When the calling system dials a 4 digit exte...

I've looked and haven't seen an answer to this problem.  I have an ISR 2921 with an ISM-SRE-300-K9.I have downloaded the CUE 8.6.6 software and have an FTP server working.  It seems as if the information is downloaded to the module, but the installat...

Hello all.I have a customer install consisiting of a UC560 and a number of phones including 8961s. The 8961s go to power save / sleep mode after a while and although the LCD display goes dark the navigation buttons light up brightly. Some of the 8961...

Hello all,   I have an instance of CME 8.6 running with working config.  I have a public IP on the CME interface.  I am able to register my IP communicator and make incoming and outgoing calls with no problem.  I have am using a 3rd party softphone a...

I have read older posts where it states that CFA is not available for Line 2.Is this still true? Or is there a way to enable CFA on Line 2 now?Thanks.Brett                  

I need to set up a call handler to only be active on the weekends.I thought I set it up properly but it doesn't seem to work.I would appreciate any help. Thank you.                  

This is a 2901 router used to connect to my CallManager 8 back at HQ. Full CM is running here and we are not using CME on each office. One SRST site is working but one is not. They just had major storms and loss power and circuits. The phone was on b...

Question - The Cisco 6500 Series switch is the acting as - DHCP Server, will this be an issue for the phones to get the needed Firmware?.Issue - A valid TFTP server must be set in DHCP option 150 or option 66 on the DHCP server.Val....

   HiI have configured cico Call manager 8.6 on cisco 2901 router.I have one BRI installed at 2901.The problem is that, when I call outside from any desk phone except the console phone the number that displays on the receiver's phone is completely di...