Hi All - I do have few queries in Call Server Logs. SIP Leg and IVR Leg are creating Unique Dialogue ID for the call. What is the use/point of creating Dialogue ID.If it's creating to identfying the call for the request send from ICM ---> ICME an...
My employee has set up her voicemail password and everything on her phone at her desk, but she has recently informed me she can't remember her password and can't access her messages. I've been told to just reset the phone, but if we do that, I've be...
Hello,We have a small handful of users that need to have the names on their 7915's updated. Can those specific phone be done through BAT or would it be easier to just change them manually?CUCM 7.1.2 Phones 7962
Hi Folks:Installing a CUCM 8.6.2 Cluster at a remote military facility, cutting over from a VERY old PBX, voice gateway is a 2921 ISR with a NM-HDV2 w/2 onboard T1. The PBX has a single PRI connected to PSTN and a single PRI conn...
Dears,I have a client who has 100 Rooms and in Each Room there are Two IP Phone 7945 have the same extensionthe License here should be one Enhanced Plus License for each room to have the two devicesor Should i order one enhanced license for each phon...
We need to present incoming calling numbers in +e164 format. From the SRND I understand that we acheive this on the gateway under "Incoming Calling Party Settings" and prepend digits depending on the incoming Number Type.We are using MGCP for our gat...
I have a ATA-187 running v9.2.1 on a CUCM v7.1.5.The ATA register correctly in SIP on the CUCM.For his Device Pool I have configured a SRST reference with the SIP network IP address pointing to the SRST-gwy.I have applied the config and reset the ATA...
Hi guys.I have Cisco 7905 phone with SIP firmware (version 8.0.1). And I want to upgrade firmware to SCCP. So I downloaded firmware files for this phone. Here there areCP7905080003SCCP070409A.sbinCP7905080003SCCP070409A.zupI configured my CME using t...
Hello AllI am about to install the above devices at a remote site with remote site assistance.Is it plug and play like the ATA187's where is gets the info from dhcp?I don't beleive the vg 202/204 have been pre-configured. What is the process of insta...
Hi,I'm fighting with a T1 CAS implementation with BTC. So far I've set up only ISDN trunks and I've a lot of difficulties so help is higly appreciated.T1 config is ok according to Telco requirements. Clock synchronized.controller T1 0/0/0framing SFli...
Hi to all,I'm in a deployment of a UC infrastructure and i just noticed something, I was testing the video conferences with the phones 8945 and with 4 participants it was working fine but when I tried to add the fifth one I got a message in the phone...
Hi ,Is it possible to set minimum ring volume on a 7940 phone .I have see this option on 7941 and higher phones but could not find any option to do the same on a 7940 phone.Thanks in advance.Prajwal
My wife found an old phone in an antique shop. Its the kind where the earpiece is on the side and you hold it up to your ear and then speak into the fixed mouthpiece. Someone retrofitted it with a rotary pulse dialer device inside the case. I conn...
