Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
hello l,m looking for sloution i have CUCM v 10.5 i have phone and I need to call Specifac number not all number on same Partition if there is any way please assiast me . thank you
Hello All,Hope you are all well!I have recently added CUCM subscriber node to the cluster and everything is working fine excepted cluster authentication between new node and IM&P servers. I get the below error on running the " show network cluster" c...
Thanks in advance to the community members here, I have a client I'm working with that has multiple locations, one of which hosts the Call Manager cluster. Recently they decided they need to move the cluster nodes to one of the other two locations a...
Hi,I'm running a mixed-mode 11.0.x cluster consisting of a Publisher (P1) and Subscriber (S1). All nodes run TFTP and call manager service. S1 had to be scrapped and replaced by a different Subscriber called S2. So I installed S2 and added it to the ...
Hellos Guys I have two branches in differents countries connedted using WAN Interfaces. SIDE A wants to call local numbers located on SIDE B so I want these numbers come out on Gateway SIDEB but I want my normal users use the international number. F...
Hi All,Encountered the error information when tried to reset CUCM OS admin password through CLI.admin:set password user admin Please enter the old password: **************** Please enter the new password: ****************Reenter new password to ...
Hi, One of the customer wants to know whether it's possible to display IVR DTMF input displayed in IP phone ? CUCM - 11.X
Recently upgraded from 10.5 to 12.5 and dont see any more license manager under CCUM publisher.Is there any way to see license from 10.5 in any files or any way???? I am running on tem 90 days license. I need license info from 10.5 for Cisco License...
Hi, Knowing that an ATA191 alone requires UCL essential license. And knowing that a CUWL standard can support up to 10 devices. Can the CUWL be used for a user IP phone and the ATA in the same time? T.
Hi,When I applied the call forwarding rule, the destination number only rang about 2 rings. Is there a setting on either the Cisco Call Manager or on the host's Cisco desk phone that I can apply to increase the number of rings?
Hi All,I hava some problem on my voip network. when I make calls to the router that PLAR to the call manager, i get an error "Disconnect cause=38" and call couldn't completely and there is a busy tone. i have tried to check and telnet port 1720 and t...
Hi, I have a user who is having an issue with his voicemail. Despite deleting all of his voicemail, no callers are able to leave a voicemail and the Cisco automated system claims that the voicemail mailbox is full. Is there anything on the Call Manag...
Configuration has been verified against a good setup and all CSS and settings have been verified. No idea why when the person answers the call that rings out to his cell but the caller is directed to the cell voicemail instead.
Hi All.I am trying get my head around something.I need to point a set of NON-DDI numbers to display a single DDI when dialing out to customers. this is so i can point this DDI back to the service desk main number.not sure where to start.any advise wi...
