Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,I have installed a new 7962G IP phone onto a CallManager running version 5.1.3.6102-1 software. The IP Phone version is 8-4-3, and the 7915 version is B015-1-0-3.The 7962 comes up okay and works fine. We can make and receive calls. However, even t...
Is it possible to connect directly my IP phones directly to an AS5300/AS5350 ( having only a switch in between). If so, do I connect them just like i would to an ISR router?
HiWe are having a site coming up which requires integration with a local Internet telephony service provider (ITSP), which supports SIP integration.The service provider will be providing the IP Address for the service and login credentials for the S...
Hello,i have the following scenario:1- one gateway (PRI Line interface)2- two RightFax serversi used a SIP protocol between the gateway and the two fax servers , my point is how to configure a dial-peers on a gateway to make an inbound balancing fax ...
Is it possible to connect directly my IP phones directly to an AS5300/AS5350 ( having only a switch in between). If so, do I connect them just like i would to an ISR router?
Hello.I'm trying to configure phone book on Cisco unified communications manager express, but when I go to directories->personal directory, or Corporate Directory, i got message "Host Not Found". Telephones normally work. In attachment you can see ep...
Back again with another question involving my 4.1(3) to 7.1(2) drama. :)So the first node is upgraded and configured, and I've managed to import the DLU's from my previous cluster. However...there still seems to be something missing.In the License R...
HiA customer needs to add in parallel Fax server wich T38 feature activate.Actually we have fax passtru activate with MGCP GW due to ATA endpoint.Does it possible to just configured on the same GW a dial-peer with T38 activate and connected fax serve...
Hello All,Call Manager on MC7845 have two ethernet interfaces. How does both work? Active/Standby , Load Balanced / Etherchannel.Can one have 1gb speed and the other 100Mpbs.Many thaks
Hi, I am running CCME 4.3 with 7941G-GE phones and i would like to do the following:when a users presses the settings button they must not have any access to any settings except “User Preferences†When a user presses the Directories button they g...
I configured three park-slots with the same number. IP Phones can park up-to three calls by pressing Park softkey. The problem is when you want to retrieve the parked calls you can retrieve only the first call that was parked. The other parked calls ...
Hi,is the extention module 7915 compatible supported with 7961G in CM Express please, because it doesn't work for me ?Regards
Hi I am hoping someone can provide a solution to support 178 Analogur trunk lines from PSTN to Interface with Cisco Unified Communication System, is there a solution out there ? Except for consolidation of T1 circuits
hi, wich of the 2 policy map can i use for the best practice QoS Voice? and why?Example 1:ip access-list extended Voice permit udp any any range 16384 37276ip access-list extended Voice-Signalingpermit udp any eq 1718 any permit udp any any eq 1718 p...
Hi All,I have UC7.x and am trying to setup Mobility (simul-ring). However, there are a group of users that do not have hardphones.The requirement is for users to use unity for voicemail (for both cell and their DID's).If the users do not have hardpho...
