IP Telephony and Phones

Tomcat and Call Manager certificate

Hi, I could see my call manager is having tomcat, tomcat-trust and Call Manager certificate as CA Signed and they are going to expire. To renew the same, i have to regenerate the certificates and have to give the same to CA to be signed and they will...

CUCM SQL Query - phone details

Hi all,We have just upgraded from CUCM 4.1 to 6.1. With 4.1 we ran the following query to extract a phone report. I am not an SQL guru so I was wondering if anyone could look at the syntax and tell us how it might be changed to run on 6.1? If not,...

Resolved! Masked Hunt Pilot/Line Group for Help Desk Outgoing Calls

Hi all, CUCM 11.5 I did my best to search Google, then signed up here searched and read a lot of discussions but could not find something solid that I could go on outside of creating new CSS, PT and then doing transformations and/or translations. May...

Resolved! Enable Web Access on CME for IP Phones

Is there a way to enable Web access on ip phones in Communications Manager Express?CME Version- 8.5Phone Model- 7965Phone Load- SCCP45.9-1SR1SThis doesnot seem to be configurable on the phone and I have not located a way to do this in the GUI.

Resolved! CUCM Report PoE usage

Hello!I am a bit new to CUCM and all its glory, but I wanted to ask the community if there is a way within CUCM Administration (or any offshoot) to run a report where I can determine if VoIP phones are currently NOT using PoE but instead are utilizin...

Resolved! License required for 3rd party IP Phone

Hi, Refer to below BoM would you kindly guide with the right license for 3rd party IP Phone to sync with the existing infra.? Call Manager Hardware 21.0BE6M-M4-K9=Cisco Business Edition 6000M Svr (M4), Export Restricted SWN/A121.0.1CON-SNT-BE6M4M4K...

Resolved! Blocking nuisance phone calls in cisco call manager

In Cisco Unified CM Administration System version: 11.5.1.14900-11, is there a way to block unwanted, nuisance or harassing calls in call manager?

Cisco Phone 8865 with Register CUCM Remove 2 Bindings

Hello, I Have Cisco Phone 8865 Software version : sip8845_65.10-3-2-16.loads, I try Monitor Cisco Phone with Program Wireshark. I see packet register with CUCM Active with Respond Status 200 OK, But Cisco Phone Request Register with CUCM Standby agai...

Cisco Phone 8865 with Register CUCM Remove 2 Bindings

Hello, I Have Cisco Phone 8865 Software version : sip8845_65.10-3-2-16.loads, I try Monitor Cisco Phone with Program Wireshark. I see packet register with CUCM Active with Respond Status 200 OK, But Cisco Phone Request Register with CUCM Standby agai...

Cisco IP Phone 8865 Keypad delay

I have a Cisco CP-8865, Software version sip8845_65.10-3-2-16.loads. Cisco IP Phone 8865 have a problem keypad delay When press number for dial. Can you please solve this problem. Thank you.

CP-7821 register with SIP

Hi, I have a Cisco CP-7821 model POE IP phone, I wanted to use that phone to get registered with SIP.I have performed the following steps for that1) Downloaded the latest Cisco IP Phone Firmware sip78xx.11-5-1-182) Downloaded third Party TFTP Server ...

Forwarded calls shows shows "Forwarded" instead of the display name

Forwarded calls shows "Forwarded" instead of the display name for newly configured phones after upgrading the cucm from 10.5 to 11.5. CUMC version 11.5Call type internalPhone type 7945 Its working fine for existing phones with the same version of fir...

Force G711 codecs on 7965G and 9971 devices

Hi, I would like some help trying to force my CISCO 7965G and 9971 devices to use the G711 codecs, in the configuration file I did not find a TAG with this option.

6921 Phones unable to register to CME

Hi guys, so we tried to load a later IOS firmware onto our 2900 router from c2900-universalk9-mz.SPA.151-3.T1.binto c2900-universalk9-mz.SPA.154-3.M1.bin by upgrading it via Cisco Prime. Due to space Prime appeared to have deleted some files from fla...

CUCM Version 12.0.1. Device Pack Installation

Hello, I am hoping to get assistance on how to properly install a device pack to support the webex room kit mini. I already tried to install the latest device pack that would allow the mini to register on my call manager but it failed. I noticed that...

IP Telephony and Phones

Forum Posts

Tomcat and Call Manager certificate

CUCM SQL Query - phone details

Resolved! Masked Hunt Pilot/Line Group for Help Desk Outgoing Calls

Resolved! Enable Web Access on CME for IP Phones

Resolved! CUCM Report PoE usage

Resolved! License required for 3rd party IP Phone

Resolved! Blocking nuisance phone calls in cisco call manager

Cisco Phone 8865 with Register CUCM Remove 2 Bindings

Cisco Phone 8865 with Register CUCM Remove 2 Bindings

Cisco IP Phone 8865 Keypad delay

CP-7821 register with SIP

Forwarded calls shows shows "Forwarded" instead of the display name

Force G711 codecs on 7965G and 9971 devices

6921 Phones unable to register to CME

CUCM Version 12.0.1. Device Pack Installation

Hearty congratulations to the December Spotlight Award winners!

Renew.cisco.com just got refreshed, and it will make your life easier!

Announcing Resources That Guide You to Success

CUCM sends wrong device ID to Recording System

CDR reports: Request for activity on multiple lines

I get dozens of these alarms on WU, but no errros on controller

Transfer Caller ID and 8800 Line Buttons CME

UCCX upgrading Error encountered: The selected file is not valid.

Cisco CP-8861 3PCC unable to dial using call history list.

CUBE - SIP trunk and Cause 65 Bearer capability not implemented

call forward not working with the uccx agent

Activation Code or Service Domain

ISR 4331 CME Licensing