Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
HiI have ccm 4.1 in my network and few users having vista operating system I m unable to install IPMA-assistant software on that PC is there any way to upgrade only this software so that I can install it on vistaRegardsTahir
what is the best method (s) to get voice quality and performace reports on a CUCM 6.X Cluster.
When you try to record a voice mail in Unity Connection using the java Appli I get the following error:Could Not create a phone recording sessionthe report error is: E_Invalid_Phone_NumberHow do you fix this please?
Hi AllHope you are ok.I am looking a way to lock the phones for outbound call during some time period. I tested time of day routing but It lock the phones apparently for indbound call only. Please advise any suggestRegardsAndres
Hi,I have set our customers 7945's with an idle timeout, which is good, BUT the users are all complaining that when they get an incoming call, they can't see who is calling because the display remains black.....is this a bug? is there a way around it...
Please see the attached screen shot capture of the steps my customer followed to try and install GBNP Dial Plan on CUCM version 7.x. Note:=====This system migrated from version 4.4 to 7.x in January 2009. All other dial plans were installed when at 4...
upgrade licensing details, how we can get upgrade license for cucm 7.0 through TAC Engineer or not.
Can I install CUCM 7.0 on IBM Blade Servers ?RegardsMohamed
I lost my password of CM administrationcan anyone please suggest me how i recover that?
hi guys ,i have a central location havng one CCM integrated with GW via H.323 and have one PRI and calls are working fine for incoming and outgoing ....( i have created Route Group, route List and Route pattern for central location pointing to centra...
hi guys,i have CCM 6.1 Cluster and two PRI lines terminating on two different routers, and i have to configure redundancy between both PRI Lines ???? how to do that ???is it possible to configure that one call goes to PSTN via one PRI and second call...
Hi guys,I have 7815 MCS Server having Memory of 2048Mbytes as CCM 5.1... i have to configure Extension Mobility on it for 50 users !!!if i will configure Extension Mobility for 50 Users on above server will it effect on the performance of server ????...
hi guys,what codec we should use for voice between two sites which are connected via 10Mbps of MPLS Link ???what bandwidth does one voip call takes between two sites ???how can we reserve specific bandwidth for voice and for data over WAN ???RegardsR...
There's probably a really easy way to do this, but I'm trying to get a Polycom VTX Analogue conference phone working on my UC520.The UC520 has an ISDN PRI (E1) on a VIC card and the standard 4 x FXS, 4 x FXO.I've plugged the Polycom in to one of the ...
Hi,I am having a lot of problems setting up a VWIC BRI in a Cisco 1861 that is connected BRI in Malta. As I am working on this remotely I am having a lot of difficulty getting information to configure this.The ISDN's will be under MGCP control; howe...
