IP Telephony and Phones

CCM 4.23 SR2b, 7961 FW version is SCCP41.8-2-2SR1S. H323 gateway 12.4(8c). Some phones mysteriously get stuck in CCM fallback SRST mode and do not re-register with CCM even though WAN is up. Only thing that gets the phones back is to cut the power ...

Hi All,after doing thisStart > Run; type CCMPWDChangerwe were able to logon, and also to able to change the password, now even after restarting the whole server we can logon Start > Run; type CCMPWDChangerand we are not able to log on, but the appear...

Hinow i dont' reveived and send call's from CCM and cisco 3825The status of BRI is ok ISDN BRI0/0/0 interface dsl 0, interface ISDN Switchtype = basic-net3 L2 Protocol = Q.921 0x0000 L3 Protocol(s) = CCM MANAGER 0x0003 Layer 1 Status: ACTIVE ...

I created several Default device profiles and for each subscribed to extension mobility services. I configured my CCM to auto-register phones. Should the Extension mobility service show up? What am I forgetting?

I have seen the ability to telnet into a SIP 7960, is this feature supported in SCCP? If so, how do I enable as my SCCP phones I cannot telnet into. Thanks in advance

Hi All,How many users can we create in CCM 6.x having all admin rights?Also, can we create a user which has only rights for viewing CCM status?regds,aman

Hi, Who know how to delete a license file from a CCM 6.0?Regards

I just recently upgraded 2 call manager clusters from 3.3(5) to 4.2(3), and as soon as I did that, my intercluster trunks failed. They are still not working, and I can't figure out why.Can anybody provide information that might be useful.These are n...

Hi guys,I did a fresh install of CCM4.2(3) on an MCS 7835-H2 with 1GB RAM and dual 18.2GB hard drives. The problem is that the CCM service keeps stopping. I get the following message in event viewer:"The Cisco CallManager service terminated unexpecte...

Hi,I have just download the CatOS config Translator, when it start up l get the following error message - See Attached Error Message.I have followed this through and started the service, but l keep getting the same error message. I am running XP SP2....

hii,i want to chang my MOH tune ao that i am upload new file but error is there"Unmapped Exception The entity name must immediately follow the '&' in the entity reference"so what happen plz sugest me................

All, When I add an extension as a shared line on a 7914, when an call comes in on that extension, the call rings on the receptionist phone as well. How can I prevent that?

Hii have ccm 5.1 i want to configure an idle background image for 7940s and 7960s, how is this done?i used to do this with ccm 4.x but here things are different, even i searched but did not find any documentation on cisco on this issue?please help, i...

we use CallManager to support emergency evacuation in a dam. Currently it's done by dialing an extension hooked to VG224 with an altered ringtone, which then goes to a Viking VG-10 to amplify the signal and run remote analog bells in the complex.The...