Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Is there a command that will disconnect a call on an FXO port say after a few minutes to limit the caller for a specified amout of time for his call..Thanks
Can we have a Publisher and a Subscriber in two different locations for a CCM ?If one of these goes down for some reason will the other keep the phone up and operational and are you limited to a certain time it keeps them working?
I have a route filter that I'm trying to implement. The idea is for local calls, to allow 10 digit dialing as long as the area code is 206 or 425. The user can also use 7-digit dialing as well. I've configured the route filter as (AREA-CODE == 206...
Hi, does anyone know when one would use the DSO-group vs. the TDM-group commands? I understand they would both be used with voice but don't understand the difference. Thanks!Thanks, Lisa G
Hi!This is the problem. If I perform a call, the autoatendat starts, and I can hear the menu options. If I hung up at this point, the line is not released, and no other call can be done since the line is busy... I think the line should be free when...
I am installing Cisco Unity and for one of the steps its asking whether on Call Manager I am using SIP vs SCCP - How would I find that out?Thanks!
I recall a command (not listed) that allows you to tell an ISR to make an actual call, as if a voice call was being sent to the router.Does anyone know this command?
i installed cisco CUOM,AND I HAVE TO INSTALL THE 1040 SENSOR BEFORE IT WORKS,I CONFIGURE THE SPAN PORT ON THE SWITCH,AND PLUG THE 1040 SENSOR,BUT IS NOT GETTING THE IP ADDRESS,AND INEED A HELP ON HOW TO COPY THE 1040 SENSOR DEFAULT IMAGE FILE TO THE ...
What is the difference between connection plar and connection plar opx? When would I use one vs. the other?
Hi!I?m trying to set the panish localization in a ip phone model 7906G. I?m looking this table http://www.cisco.com/en/US/partner/products/sw/voicesw/ps4625/prod_installation_guide09186a00806dad6a.htmlAnd I have tried with the files from here:http://...
Hi, When you've got a bandwidth statement,does that refer to just codec bandwidth, or does it include layer 3 & 4 overhead? and, when a call crosses 2 zones, does the bandwidth used for a call get deducted from the source zone or hte destination zon...
Have a 0.X route pattern using OverlapSending. Everything works OK for PSTN calls.But when trying to CFwdALL to a PSTN destination is impossible, the diverted number is accepted straight away after 2nd digits.
I am trying to configure dial plan in CAR but I don't know to change the default plan configured that is North American numbering plan.Can anybody help me?.Thanks.
I have a callmanager 5.1 with MGCP PRI. The requirement is to block incoming PSTN Caller ID for three 7941G IP phones. Any suggestions?
Last week a customer asked if they could install an authentic digital certificate from a 3rd party, like Verisign. I honestly didn't know the answer - I've never done it before. I suppose it's possible but wanted to run it by the guru's here.
