Hello,Does anybody knows if ME3x00 with version 15.3(1)S supports PIC Core/Edge .. the commands are there (and they "commit") but i haven't seen any reference to it .. Thanks!David
We have problems with a VPLS service for a Customer. The edge devices are Cat3560 and ME3600 (where the Customers sites are connected).When the edge device are ME3600 we have problems getting the traffic on the Native VLAN from the Customer out in th...
Hello,I have issue with egress policers on EFP (Service instance).When configure two egress policers on EFPs (on one physical interface), I received a message:ME-3600X(config-if-srv)#service-policy output VLAN-50MQOS: egress police command not suppor...
Hi guys,NTP synchronization on ME3400 takes around 10 minutes and I couldn not find way to reduce it.The problem is with restoring dhcp snooping database from flash/tftp after switch boots up. Database is restored after clock synchronization, but 10 ...
I am facing with a case where it would be useful to have qinq support on private vlan trunk port. I would have about 10 primary/secondary (isolated) vlan associations. Secondary vlans would be tagged and accessible via pvlan trunk port. So far nothin...
What is the different between ATM rfc1843 routed mode and bridge mode This is what i see for the configuration, some one could explain to me why is it need to configure like this? RFC1843 routed mode need to have configuration ATM protocol ip xx.xx...
I've been using SIP/SPA 2x1GE with this config for connecting customers:interface GigabitEthernet2/1/0.64 description edge1 bandwidth 100000 encapsulation dot1Q 64 ip address 192.168.2.1 255.255.255.252 ip verify unicast source reachable-via rx allow...
Can someone please help and give suggestions and possible configuration options for setting up metro ethernet in the following senario:Will be setting up ME between headquarters and three remote branch offices. Each remote branch will be provisioned ...
Hi,We have a dot1q tunnel soution for a customer. Port Security (100 mac addresses) is enabled on the dot1q tunnel ports.It seems like packet drops occurs exactly every 3,5 min (210s), which is same as the port security aging time.Is this a known pro...
Hello,Quickie....New temporary site 1 mile away from main site connected to MPLS.We want to connect new site with a 10M ethernet connection to existing site.Can i just throw a L2 switch in the new site (extend the LAN)?We have a flat topology. Or doe...
hello all;i have PA-MC-STM-1SMI in my 7206 VXR; and i need to configure some link but not E1for first i need to configure a grouped VC3 in one interface,and i have 34M link between 2sites so 14VC12, and i need to have just one interface with 34 M ba...
