Network Management

I've clealy missed something fundamental, but i can't find it anywhere.My old 3.2 installation works perfectly, sends email alerts when error or performance thresholds are exceeded, or  interfaces go up or down.I've installed 4.2 on a new server, it ...

Hi all.We have deployed a Cisco NAM-2 on a Catalyst 6500 in the CPD.We're capturing traffic by monitor-session configured on vlan 200 on NAM's data-port 1 like this:monitor session 7 source vlan 200 , 403 , 500monitor session 7 destination intrusion-...

I have to config Lawful Intercept on 7600, IOS version 12.2(33)SRC6. Every step have be taken by "Cisco 7600 Lawful Intercept Configuration Guide".Such as:Router(config)# snmp-server view tapV ciscoTap2MIB included Router(config)# snmp-server view ta...

Hi.In a Catalyst switch, under the command: show interface fast 1/0/1 (for example) there is a parameter "5 minute input rate YY bits/sec".Is it possible to send this value to a SNMP server or to a SYSLOG server?  Danny.

Hi team, Okay, so what we have observed in our network is that flow-export sometimes causes high interface utilization and as a workaround, we remove and re-add flow export commands. Now there are short burstd of traffic as well, so I want to add a ...

Hello - I'd like to take advantage of the 'protected port' feature of my SG 300 and SG 10 switches, but it seems that the isolation offered only works with devices within the switch - i.e. it does not isolate the port against the switch that the swit...

Dear all,.Is integration of LMS 3.2.1 with ACS 5.3 now possible ? (I understood from this forum that early ACS 5.x could not integrate wih LMS 3.2, but that this feature would be restored at one point in time (5.1?)).Thanks for your help.Yvon.

would you explain the main differences between lms 3.2 and 4.2 cause my company is about to purchase the new version;- how does it changed in taking reports ?- how does it changed and improved in monitoring ?and what kind of questions should I ask my...

hi, i need to know the descripiont about the "event updated" column in the alert and activities window, in this document http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_device_fault_manager/2.0_IDU_2.0.3/user/guide/useAAD.html#wp1282510  i have f...

LMS 3.2  can't open Manu Device Troubleshooting only begin I will check manu Device Troubleshooting but LMS 3.2 can't show detail about Device and show error on windowsI need fuction Device Troubleshooting becouse ATP customer.PS. LMS 3.2 on windows ...

Hello,i'm a newby in LMS, and i need your help I want to purge all jobs for the last 30 days, but i wonder if i will able to see again data of this jobs after purge?As i can't find any information about how to do that, i though that i could export jo...

I am trying to figure out why the Device view has no systlogs in Cisco Prime 4.1I have everything configured, the switch is sending debugging level logs to the IP of the Prime Server. I am fairly certain it is reporting because it has alot of other i...