Network Management

Hi,Currently we have CiscoWorks LMS 2.6 and looking to buy or if possible upgrade to latest version of CiscoWorks LMS 4.1I need confirmation is this LMS 4.1 is a bundle? Like including RME, Common Services, CiscoView, Device fault Manager, Campus Man...

Hi All,Has anyone came across this weird bug that when you configure ip sla in proactive with xofy, it will generate two syslog messages?Here is how I am using it:ip sla reaction-configuration 3 react rtt threshold-value 100 70 threshold-type xofy 2 ...

Hi all,with LMS 4.1 running on solaris 10 I discovered the follwing.Adding larger amount (>10) of devices one after the other (via DCRCLI) results in IC_Server no longer collecting the Inventory-Data nor ArchiveMgmt will collect Configs and after som...

I'm wondering if other people are seeing this and perhaps have had an adequate response from cisco.I regulary find the the numbers displayed don't match the reality, and now I have the most stunning example so far.I have a customer who doesn't use fa...

Hello,  How do you know when they will release a new version.  Is there a place that will let you know when a update is coming?

Hi,We tried to distribute the softwer ( 12.4.23 ) via LMS 4.1 but we got the following message:"""Device is locked for exclusive access.The supported protocols for image transfer are: TFTPSWIM1001: The input parameters to the Image Distribution/Image...

Hello Community,we are running CiscoPrime LMS 4.1 and I have a problem with PingSweep in Device Discovery.Our company's branches connect to the main site through GETVPN. Discovery through CDP, Routing Table and ARP cannot be used based on the documen...

I want to know if it is possible to install LMS single server installation for the purpose of backup.Better still how do i perform backup for LMS installation for the purpose of disaster recovery.

Hi all,Can anyone tell me if it is possible to add an ASA and ACS to LMS 4.0 device management?Does LMS also backup the config of those devices?Thanks,Best Regards,Joris

Hello,I have some problem with WS-C4006 Cisco Catalyst that lms doesn't collect and put into "never collected" area. I also see that those devices doesn't show the classic prompt ">" and "#". Could be the main problem ? If yes how can configure LMS t...

Hard drive is getting full on LMS 3.2  The only thing this server is running is LMS and Wireshark.  What is safe to delete to help free up space.  Or is there a setting to purge the database so that old data isn't kept for so long.

Hey everyone. I'm currently testing LMS 4.2 and I setup a new install. I was able to discover devices, check and backup configs and check for compliance. One thing I can't do is setup pollers to monitor performance. If I click on setup (or any of the...

Dears,I config LMS to manage many network devices with the same credential. However, only the Nexus 7000 fail to be archive configuration. LMS log said during telnet, the authentication fail 3 times. (I didn't use any authen server. The username and ...

I've clealy missed something fundamental, but i can't find it anywhere.My old 3.2 installation works perfectly, sends email alerts when error or performance thresholds are exceeded, or  interfaces go up or down.I've installed 4.2 on a new server, it ...