Hi,We have just noticed that CiscoWorks is not collecting syslogs from all devices but from only few devices.I have attached syslog_debug.log file, please review it and advise that why we are seeing "CRMLOGGER- size is 0" messages.Our devices are con...
hi, I have set the network discovery setting to use (arp-ospf, and cdp) . after the network discovery was finished I found out that there are 30 devices which had been discovered but in unreachable state !!!!I start to ping all those devices and hopf...
hi, I am using CiscoWorks lms 3.2.1, and I have the related tutorial CWENT version 2.5, and there are too many differences, I wonder if there is any new version available ?thank you .
Hi !i would appriciate any help with this one :i have an ipsla that pings a host .if syslog message "%TRACKING-5-STATE: 222 ip sla 333 reachability Up->Down" has happened 2 times in 3 minutes, its putting a null route .what i would like to know is ho...
In Logs.26-oct-2011|14:37:25.515|ERROR|AAD|TP-Processor6|DeviceManager|getHighSeverityAlerts()|.|com.cisco.nm.trx.afd.AlertRenderer.AFDException at com.cisco.nm.trx.afd.AlertRenderer.ViewDataHandler.getAlertDataPortal(ViewDataHandler.java:822) at com...
Has anyone setup LMS4.1 soft appliance in a HA (active/standby) setup? Config guides only mentions windows and solaris setup using HA but nothing about the soft appliance. I am guessing that I would only need license on the active box. Thanks
In my LMS 4.0.1 on wondows installation, the backup job fails with:"[Fri Oct 28 11:19:10 2011] ERROR(1297): Fatal error: Database engine 'ipmEng' could not be started on database 'ipm' in Bulk mode.."I have also tried running the backup manually wit...
Hi,LMS 3.2,the devices are not shown in the CS.In CS Device management no devices are shown(0 devices).But devices are shown in DFM,RME and IPM.Any help??Regards,Channa
Dear experts,does anyone knows what is difference btw c2960-lanbasek9-mz.122-44.SE1.bin with c2960-lanbase-mz.122-44.SE1.bin.I found that these two IOS are available in below link and both two are released in same time... any advise would be apprecia...
All,i've been tweaking my syslog server and how my Cisco environment recently and it's nearly there apart from one annoying message that is cropping up all the time - my question is, is there an easy way to filter this message:%DSLSAR-1-DOWNGRADEDBW:...
Some background info: I attached a simple version of my network. I haven't turned on failover yet as I have a few questions. You can see two links coming out of the ASA and into the next switch. One is for the inside interface and the other is for t...
Hello,I'm trying to install LMS 4.0 on a 2008 R2, I got a message saying that this is not supported. Going through Cisco documentation I read the following:Caution If you want to upgrade the operating system from Windows 2003 or Windows 2008 to Windo...
