Network Management

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

I need to set up syslog for my Cisco 6509, but I'm at a loss to how I set a path. I can set a host or IP address for my syslog server, but how do I tell it what path/folder to use?

HelloWe're experiencing quite 'demanding' space requirements from our backups.  Within the dbbackup.log sometimes the backup fails due to insufficient space on the disk.  Currently the space required is stating 60gb.  Does this sound quite excessive ...

dmistry21 by Beginner
  • 4 replies
  • 0 Helpful votes

Hi Guys,Quick question.I am using the switch port summary report in Campus Manager quite happily, however I have a question with regards to the data and its frequency of acquisition. For example both Connected and Free ports are based on data that mi...

tim by Beginner
  • 6 replies
  • 0 Helpful votes

Hi,I'm currently deploying a Nagios monitoring solution on my network. So what i'm trying to do is getting an alarm when there is a lot of traffic or errors packets on a IF, i get it like that in my snmptrapd :2011-05-12 10:58:21 <UNKNOWN> [UDP: [10....

I have been having some problems running discovery and executing device management functions. The common problem is that I am getting:ErrorError in communicating with DCR Server. DCR Server may be down. Please start the DCR Server and then refresh th...

Marvin Rhoads by Hall of Fame Community Legend
  • 8 replies
  • 0 Helpful votes