Network Management

Is there a "range" command to verify if BPDU packets are being sent/recieved on all the interfaces on a switch at the same time?  Or do you have to run the command: switch#show spanning-tree interface g1/0/52 detail | i BPDU   BPDU: sent 3, received...

hello guys im still new and right now working on redundancy project in eve-ng.the problem is that my vlan client can only ping vlan host in switch and cant ping anywhere else but the vlan host can ping another ip even google. i tried trace route it b...

HI All !I am new in Cisco pl help me to configure IP CAM NetworkWAN IP - 103.77.XX.XXX 255.255.255.248 (PUBLIC IP)LAN IP - 172.16.35.1 DHCP SERVER .172.16.35.1 255.255.255.224NAT scriptits a new router/me,  so please share scripts in details !Thanks ...

Hello. I'm currently doing an assignment for my class and I'm having a little trouble with DHCP handing out IP Addresses from pools that I've configured for different VLANs.I've got the topology here: PC21 is the only one getting an IP address while ...

I am trying to block some applications using the Router Cisco Firepower 1010, yet users in my network are able to execute applications as torrenting and browsing porn sites despite declaring in Access Control under Policies to block it. The screen sh...

Upgraded a 5000 series switch from 7.3.1 to 7.3.2 and now a previously successful tftp backup eem fails to run and the error message reads: cisco eem_policy_dir policy expired. I can run the backup command by itself and it works. This is not a lot of...

I have a Cisco Prime PI-UCS-APL-K9 version 3.1.0 appliance that does not start, the symptoms I present were the following:1- The device lost management by GUI but allowed access by SSH "CLI" and responded PING2- The device does not respond to the pin...

Hi everyone.  Today, we got a scenario where in our network someone may be plugged into a router with DHCP enabled which is just interfering with the network's DHCP. Now we can't go manually to check where the router is and we even don't have its MAC...

We are running CPI 3.9.1 and would like to add details to the message body of the alerts that are not appearing. I have not found how to modify them in CPI, the only thing I found searching is a ten year old post asking the same thing here and being ...

I have tried the following fix but then I get another error:"If you go into Start > Cisco ASDM-IDM Launcher > right click the launcher and go to More > Open file locationThen you'll be looking at the shortcut to the ASDM launcher, right click it and ...

Hello there, I'm trying to set an applet for auto discovery of interface description.  (config)#event manager applet update-port-description-cdp(config-applet)# event neighbor-discovery interface regexp HundredGigE.* cdp update(config-applet)# action...

We have a layer 2 network that we're trying to configure flexible netflow for on our 2960X (mostly) switches to send to our traffic analyzer.  Basically we want to configure netflow to monitor our layer 2 trunks so we can see the bandwidth numbers on...