Network Management

Has someone come accross something like this.I have 4 sites.Each has at least 1 stack  and then 3 other Cisco Switches in the site each connected by fibre to make 4 devices per plantLMS Reports 16 Devices which is correct.Here is my issuewhen reading...

Dear *,If for any reason my LMS applicaiton is not opening which services should i check on Solaris 10 server and in which state should they be and how?Thanks,Aamir

We have LMS 4.0 installed on a Domain Server local admin account.I am trying to schedule backups and config archives to a network share.Backups to the local hardrive are working fine.I have created the backup job using several different domain accoun...

All,I've been experimenting with the log rotation feature from LMS 3.2 UI (CS > Server > Admin > LogRotation) and have noticed when I try to schedule the logrotation with any backup directory (/var/adm/CSCOpx/log for example) it indicates that I cann...

Hopefully Joe Clark will see this,We have a clean install of LMS 4.0 on a virtual server, a single 2.4G processor and 4G of RAM.I do see the paging file size is 4G and recommended is 8G.The install was pretty smooth and everything seemed to be workin...

Is it possible to monitor services on Call Manager and IPCC  with LMS and alert via e-mail if a service goes down?Or possibly even dial a number if a service is down?We have the servers in LMS 4 and CPU is being monitored, and I have an inventory of ...

Hello,I am getting port faulty message as shown below. How can I investigate further?SW02> (enable) show port status 3/26Port  Name               Status     Vlan       Level  Duplex Speed Type----- ------------------ ---------- ---------- ------ ----...

Hello all,does LMS 4.0 capable to monitoring QoS? (basic QoS monitoring is enough, not spectialy for IPT, but for overall traffic)Or do i need dedicated MGMT to cover this?Thanks for response

HI Friends,I have installed Ciscoworks 3.2 on Dell poweredge 2950 server, when i try to configure SMTP email notification settings, it's giving me error "Invalid IP address or server name please enter valid SMTP server name"Request you to all please ...

Hi there,We run CiscoWorks LMS3.2, and recently upgraded our old routers 2600 series to 2900 ( 2921 ). However for some reason CiscoWorks does not seem to recognize these new devices. We have tried removing a device and rediscover it but we are still...

Hello. When I change configuration for the ASA device with LMS 4.0 Configuration-->Tools-->Config Editor, the configuratin changed, but the job fails with the Error:Deploy command partially failed TELNET: Failed to establish TELNET connection to 172....

Dear all,It's me again...I have tried to configure IPSLA using LMS and I'm quite surprised that even if the collectors are running:and my tagrget has received the IPSLA responder commands - no commands have been received on my source router so my sta...

I have a Cisco 1721 Router and I am looking to monitor it for hourly statistics to find max and min speeds.  How would I go about doing this?  I know if I do a show interfaces it shows me all the data since the last time the counters were reset.  Tha...