Network Management

I have just installed LMS 2.5 on Solaris 8 including CiscoView. I believe I have installed the updates for all components and all device updates for CV. Unfortunately, I can't look at ANY device with CiscoView. I always get the following message:M...

Hello,Is the CiscoWorks LMS 2.2 can be integrated with the HP Open View if yes How and what's the the functions that can be done with the HP Open View and not by CiscoWorks LMS 2.2.Thanks for your help.

i search for a software which take my routers config. .bin and also txt and save in its databaseThanks in advance

Since Cisco Clean will authenciate can it take the place of Cisco Secure? Has anyone done this swap? Thanks, Laurie

Ciscoworks VMS IPS management center works great downloading the latest IPS signature files to the VMS server, however I can't figure out how to auto schedule their installation, and have to manually run the install from the IPS Management Center. C...

Hi, I have installed VMS 2.3 restricted ver for Windows freshly. When I click in Security centre for Firewall routers, IDS or PIX , it gives internal server error and does not open the web page. What could be the cause? We have formatted and freshly...

We bought nGenius v1.2 alongwith Cisco Works some time ago but never use nGenius. Now I have installed it on Win 2000 "workstation". I want to monitor a network of 6509 switches with CatOS 7.6(10). When I try to add a switch, it does add switch but g...

Hello,I want to monitor via MRTG our VPN3000 concentrators, but I didn't success. So first I tray to execute "snmpget" with an explicit OID and I received the error:Error in packetReason: commitFailedI use net-snmp ver 5.08 over FreeBSD. By the away ...

Hello!Does anybody know is it possible to limit specific Cisco-device based interface information by iftype or something else with snmp view commands or something else in IOS? Many NMS:s could make use of that feature not getting too much information...

Please I nead the tutorial of:*CiscoWorks Campus Manager 3.3 *CiscoWorks CiscoView 5.5 *CiscoWorks Device Fault Manager 1.2 *Cisco nGenius Real-Time Monitor 1.4 *CiscoWorks Resource Manager Essentials 3.5*CiscoWorks Common Services Software 2.2 I ca...

Hi,This is my problem. When I try "Setup > Switch Parameters > Switch Information" on the NAM web interface, I get the following...Switch InformationPerforming SNMP test from NAM (127.0.0.91) to switch (127.0.0.21)Access to the switch failed. This ma...

All of the event collectors for IPM are running properly and I am able to view real time and historical data. When I view the Configuration Reports=> Latency or Configuration Reports=> Jitter, there are no reports there to view.Is there a setting th...

I found I seem can't received OSPF disconnected Trap on NMS when the FWSM outside interface disconnectedI want to know FWSM (2.3.3) whether can support OSPF Trap or MIB

Impossible de gerer les group dans campus campus>admin>group : Error Error in communicating with Group Administration Server.It may be down or not yet up. Please make sure that the Group Administration Server is up and running, then refresh the pag...

Hi,does anybody know if it's possible to get the information from the command 'show idb' from some snmp mib? It's not important to get all the detailed information, the summary data will be sufficient.Regards,Tomas