Network Management

Hello, I have  traffic of about 15Gbps coming into a 40G interface. I like to have traffic graphs based on the flows (recognized with source IP addresses) inside this traffic. I can use a NAM appliance 2320 and can direct the traffic to a ASR9K or 76...

 I need to monitor BGP IPv6 peers on an ASR9K router. And I'm having trouble locating the MIBs. In the SNMP Object Navigator portal I located only the BGP IPv4 MIBs. Someone knows where could i find those OIDs for BGPv6?

hello,syslI want to send the log message from n9k (version 6.1(2)I3(4b))  to syslog server. I do the configuration as follow:interface mgmt0  vrf member management  ip address 10.8.91.31/24logging server 10.8.0.103logging server 10.8.209.80logging se...

In case someone else runs into the same issue as me:I ran into an odd issue with IWAN when adding a site. APIC didn't accept my ASR router being added into IWAN inventory at first. It gave a warning about ipsec license not being present. I made sure ...

hiI have a 4431 with IOS 15.4(3)S6a which works well.A cisco engineer advises me to upgrade in 16.5.5 so I did it... but router crashed. In checking crash file, it seems to be one of my EEM script that crashes router after the reload command, see bel...

Hello all,I am trying to connect to the console port of my cisco vpn concentrator 3000. My putty configuration is what the cisco technical doc suggests. I have a female rs232 to usb to use one of the virtual COM ports on my laptop, however I am not h...

HelloI'm writing regarding an issue of high CPU utilization that I have on a Cisco Router 2911. It appears when any traffic longer than few seconds is started. I have gone through many documentations and forums and for now I haven't found the right s...

Hello,   if i want  to configure  the serial  interface  between  a  cisco 4331  AND  cisco 2921 ..  is it possible ??  or  to configure this option just can be done between routers  of the sam family  ( 4331 ) . 

I have a Cisco SG350-28 switch I have configured,  It's the 2nd switch in line of my route switch. I used to have connectivity to it until a 3rd party installed a new piece of equipment on my VLAN.I can ping the switch (10.2.3.3) through my firewall ...

I'm looking to use a cli script in Prime to reboot a certain group of APs late at night. I've tried:#INTERACTIVEconfig ap reset AP01 <IQ>y/n<R>yconfig ap reset AP02 <IQ>y/n<R>y...#ENDS_INTERACTIVE Which works fine for the first few on the list, but e...

Hello Guys, Can anyone help me here? I am trying to set ip routes between 6 districts and I am able to ping between 2 districts "Corozal and Orange Walk" and vice versa. I am a bit confused when trying to configure the ip route from Corozal to Belize...