Network Management

Hi Community,ISR C1101-4P connected to lan interface of ZTE H268Q (VDSL50) the problem is that some websites can't load quickly,shows connection time out and some other's load correcty.I have made adjustments with  IP TCP ADJUST-MSS 1452 and IP MTU 1...

I downloaded https://cfnng.cisco.com/mibs mibs to register with NMS and checked cpu, memoryoid, but the value doesn't come upCan anyone tell me the value of snmp v2 cpu, memory oid of 9300-24p, please help.

Hi everybody.I am **lly new with Cisco and I am currently struggling to set up my new switch (Day 0 setup).The switch does not generate an IP **bleep** for the connection to my laptop.Laptop is in client mode. Server resetted (hardware button) severa...

I am working on connecting some upgraded circuits from our ISP and am having a hard time navigating the dual links that were ordered. I'm working with Catalyst 9300s running 17.5 and am trying to connect both links through my routers. They are dual 6...

Hi,Is it possible to have the USXGMII specification, and any technical description.Thanks,

Can anybody help me regarding Network configuration manager. If we want to deploy NCCM in our network then what configuration will be required in network devices.

I am  working on a eem script and struggling to display a script output line by line on a syslog. It show mab all sum and the result is usually like this : Interface Client Mac Authen Status Gi1/0/1 aaaa.bbbb.cccc SUCCESS Tw2/0/2 cccc.dddd.eeee FAILE...

I'm trying to patch install 6ea ise consisting of pan/mnt and psn in version 3.2. Does downtime occur between tasks?

Hi,Switch - CISCO Catalyst 2960-48TT - NTP time sync issue.NTP server is Windows Server 2022 (Domain Controller).Pls find below command output step by step for easy understanding.CSA_SW#show clock detail.19:28:40.268 IST Fri Dec 8 2023Time source is ...

Greetings,I have two questions about building bfd session:1. As the customer requested, we tried to set bfd multiplier 2 & bfd minimum-interval 5000 on our bgp neighborship, it failed. But we then tried 3 & 500 (refer to the existing bfd setting on o...

I saved the project normally yesterday and when i went to open it this morning I got this error message. Is there anything I can do to recover my project?

Just received some 8300s and am attempting on configuring the dial-peers and voice-ports and am not having any luck.  I must be missing a step pror to being able to configure these.  I have a config from my 3925E's that I am trying to duplicate.  I u...

I have a trolley load of end of life switches, firewalls and access points that I was going to skip, but then heard there was a takeback and recycle program run by Cisco.  has anyone used this program?  is it available in the UK?  I have raised 2 RFI...