Other Collaboration Subjects

Hi,I know.. silly question..My customer is using the My Fast Dial Service via CCM 4.0(1) sr2. Each time my customer hits the Services button, and selects the My Fast Dials Service, they get prompted to authenticate with their UserID and Password. W...

Can any one, explain me how to setup a Call Detail Record in a CME system?

Get fast busy when I dial: 9 (D-tone) FFF-XXXXHowever when:9 (D-tone) FFF-XXXX works just fine.The Route Pattern: 9.[2-9]xxxxxxThe only prefix that gets a fast busy when dialed as a local number. Looked at "Prefix Digits (outgoing calls) set to (XXX...

how can I create a phone book to my 7940?Thanks,

We just recently upgraded to CCM 4.0 and I am getting complaints that when trying to transfer the call just stays on hold, and doesn't complete the transfer. Any Suggestions. Thanks

Hi,I need to integrate a PBX with a MGCP gateway thru analog E&M interface ports. Does the MGCP gatway protocol support E&M analog interfaces ??? Or I have to use H.323 gateway only thanks Renzil

Does anyone know where I can find a definitive list of disks that should come with Call manager 3.3(4), Unity 4.0(3) and PA 1.4(2)?

Hi,After Installing CRA on the Call Manager and rebooting the Server, when Itry to start the Cisco CRS Administration, I get the following errormessage:Cisco CRS Administration: HTTP 401.1 Unauthorized Login FailedI checked up the solution form this ...

Hi guysWhen we use mgcp auto download function, the router will gets the following commands from CCM automatically. My question is: If we have to manually config the MGCP, how many commands out of the below we need? .Usually I only use the first top ...

Dear all,Is there a limitation on the number of user in the same meet-me call using 7960G and 7936 respectively?Thanks.C.K.

Please show the method for the following case:Insert a "0" in front of the caller number, as a result the missed call will include "0". In this way, users can just press dial on the missed calls for returning calls.CCM version : 4.0(1)sr2aOS version...

We have a few hundred 7940 and 7960 phones and users (including myself) constantly experience interference through the phones speaker when they are not on the phone. I have noticed that when my phone switches it seems among towers or signals it does...

Can someone point me to a Cisco link (or any link for that matter) on how to configure SRST.Thanks

How can assign DID numbers to only specific extensions? I want to assign these after extensions assigned.