Other Collaboration Subjects

We have a 7830 that had Windows and SQL installed, but the CM software was not. I installed Call Manager 3.0(8). After reboot I went to the Cisco Service Configuration program, but that just crashes (Runtime Error - Abnormal Program Termination).The ...

Hi, I've just installed a CM4.0.2a with AD integration as documented on http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_installation_and_configuration_guide09186a00801ed28e.html.I can see all the users in Global Directory, however I am ...

Hi,I have a central site running Callmanager 3.3 cluster and a remote site of about 20 phones running of the same cluster.I want to setup transcoding and have configured a VG200 with an NM-HDV which is all setup and working fine and configured within...

I am helping to design a IP telephony setup that will end up encompassing 3000 thousand phones. In the campus designs that I have done in the past, if the ammount of phones/Pc's exceeded the switches capacity, I'd stack a couple and feed a Core swit...

Hi all,our customer has big problem connect their userstrought modem gateway C3640 installed with 2 channelized E1/PRI card and card NM-30DM (30 dig.modems).Gateway is conected trough PRI to PBX.I attached part of conf and debug files.Could someone h...

Dear All,My network has a 2 x CallManager Server (one is publisher and the other is subscriber).When the publisher down, I found some service is failed (e.g. call forwarding).What IP phone service will not function when publisher failed? Also, is the...

I have a location that is reporting:"Incoming calls sometimes pop up on the phone as two separate calls. When picking up the line, the call is disconnected and the 2nd call disappears a few seconds later as well. The calling party experiences that th...

Is there a method/application that will allow a user to place their phone in an 'away' state that can then be viewed from the Attendant Console? I'm looking for a method to allow the Receptionist to know, via the Attendant Console Directory, that so...

Hello,I have few questions regrading SIP proxy server and Cisco IP phones and call manager.1.Can SIP proxy server do conferencing functionality like Callmanager?Do you need any hardware resources for this/2.If I have SIP phones do I really need callm...

Is pickup/Gpickup supported for a line that is ringing within a Hunt Group? We are using CCM 4.0(2)a. Nothing happends when we try to pick up a ringing line that is part of the Hunt Group (the Hunt Group is set as broadcast).Thanks,Chris

We had SRST working fine with the 7960 phones, that is until we tried to implement the 7970s.The 7970s will automatically pull an address from the SRST router and think they are in fallback mode, even though the WAN is up and the 7960s are working no...

My company has a point-to-point T-1 line that is connected by two cisco 1721 rounter, that connect our two offices. we have two lotus domino server that talk to each other & can route internet traffic depending if one link goes down.We had someone se...

Is it posible to page to a group of ip phones? example of use would be to announce a parked call when there is no external paging system. If so, is there a document that explains this.

3660 PRI is configured as network side, 3745 is user side. ISDN status is ok. One analog phone with xt 5000 is attached on the 3660 FXS port. Run csim start 5000 on 3660. it rings.but from 3745 doesn't work. But the debug isd q931 shows connected whi...

Hi, Is it possible to customize the MeetMe conferencing to ask a new participant their name before allowing them to enter? I would like to be notified that a new participant has joined the conference by hearing a beep, then their name. If this is n...