Other Collaboration Subjects

I am little bit confused with this topic. I need a report which displays all the calls made by users on daily basis. When I see in the discussion forums, people are talking about CAR tools but I am not sure if it can be used in CUCM 7 or not. When I ...

Could someone plese describe the difference between a CTI Port and a CTI Route Point?Thank you

hi everybody, i need configure the general manager phone's with this, when someone call him all his calls must transfer to his secretary, depending who is calling the secretary transfer to his boss again, i use the CFwdALL in the general manager phon...

When I do a search by directory number->begins with 559 I only receive (46) 55900-55926 results. I should be receiving over 80. It won't show anything that starts with 55927 and up, which should show up in the original search of anything that begin...

pls help as to how can i configure a pvdm on a voice gateway to be use to terminate voice(tdm to voip)thanks

hello,is there any configuration needed for a pvdm in a voice gateway?thanks

Hi all:I have a 2851 as a MGCP Gateway and a CUCM and the deployment is working partially; because of duplicate subnet in two offices I teied to use NAT to reach IP phones from GW but it looks for real IP address.NAT is supported on VOIP solutions? W...

We want to provide the CCM with and Public IP to provide telephony service to SIP end user, but I want to now what are the consideration that I need to see.Ex. support, security, availabilityany idea?

Hi,We have 2801 CME router. Also I connected a fax to this CME. But it gives communication error when sending fax and sometimes receiving. I tried with ATA and FXS ports but still the same problem. When I connect an analog phone to this line I can m...

Hello, I can understand that you can get configuration status from SPA2102 using a http//server/somedirectory/file.xml, I have tried that but nothing happening. DO I need to handle the POST from the device (how?) or I can only get it after requesting...

Can anyone expalain how to set this so that agents can log in to a “guest account” to our hotline agent group and my question is can the account be mobile as in logged into different phones using extension mobility or does the RMJTapi agent requi...

I take the time from a ntp server in my cme router.2801#show ntp associations address ref clock st when poll reach delay offset disp*~194.27.110.130 131.188.3.220 2 873 1024 377 0.000 16.437 18.656 * sys.peer, # s...

Hi. I'm running CallManager 4.3(1) and am using 7975 phones. We are tying to get a 7916 expansion module working on some of them. Can this be done? I'm using service release 1 of CallManager