Other Collaboration Subjects

Hi,I want to know if there's a way to force the outside dial-tone right after the access code "9" ? Even though there are still lots of patterns that could match ? I've read a few posts and no one seems to have found a solution for that. My users are...

Trying to install CM 4.1(3) on MCS 7815 l2-CMA1. But the Hardware detection CD Says " This OS Version doesn't support the detected server " and installation aborts. Can any one help me.

Hi, Our customer is using IPCC Enterprise with following components, CCM 4.1(3) SR3 IVR 3.5(3) SR3 ICM 6.0 SR7 CTIOS 6.0 SR4 From last couple of days we are intermittently facing problem that IPCC agents having 'Not Ready' state i...

dear sir, We've both ipipgateway configured to communicate with each other. Attachment pngipipgw1 is our local voice router with destination pattern 3XXXX that need to link with other country Japan with destination pattern 7xxxx . All other country l...

err disable

Hi, Our customer is using callmanager 4.1(3).There are around 100 IP phones and 2000 analog phones(connected to VG224/VG248) registered with callmanager.I would like to know whether it is possible to initiate Meet-Me conference from analog phone?

We need connect IP Communicator via VPN tunnel with CME in our LAN.Beacuse high bandwidth reguested using g711 codec, UDP/IP and VNP overhead we need to setup g729 codec for CIPC.We try to setup "Optimize for low bandwidth" in CIPC preferences but g...

I have a couple of 7941/61 phones I need to load 8.04sr1 on. I downloaded the zip file and unzipped and now have 5 .sbn files and 3 .loads files. Do I copy all of them to the TFTPPath directory of each Call Manager including the term41.default.load...

Hi all,I've found an unusual problem with speed dials under ccme 4.0(3). I have a 7970 with 2 7914's attached. The first 7 buttons on the 7970 are used for lines, I have left button 8 unused so it can accommodate a speed dial.Buttons 9 through to 36 ...

In working with devicelistx, I have found that every so often I get a record with a status code (s=) of 3. Thus far I have not found any doc that enumerates what 3 means. It is a relatively uncommon occurence. On clusters with an average size of 6...

what is the max number of Unity integrations I can have on one callmanager cluster?

Is there a workaround to the 2 calls per shared extention on the 7920?

I have about 200 users on two CCM 5.0 servers,the directory service keeps on hanging and becomes inaccessible and the service comes back after some time,any ideas as to the cause and remedies ?