Other Collaboration Subjects

I have to develope a service that is: ALARM CLOCK for hotel rooms The user inputs hour and minutes using a xml-page. When this hour will be a sound will be sent on phone . I Know how write data in DB and how send sound but i don't know how execute se...

Hi,One CCM Cluster (v4.1(3))with two callManagers are located in the head office, all the ip phones in head office are fine. However in the remote site, all the ip phones can be registered to one of the two CallManagers only depending on option 150 p...

I have one problem regarding WS-C6513 switch using CatOS command. I notice that the ports connect from the user to the module ports will keep on shutdown for no reason. The worse part is i have to unshut the port one by one. It really waste a lof of ...

If you have some devices that use Locations and some that do not do the devices without a location assigned default to unlimited voice and video bandwidth?Thanks!

Hi guys,I have 2801 router, LOCALLY I have 50 IP phones connected in a LAN, these IP Phones need to call PSTN and vice versa (PSTN should call IP phones) so I need an E1 carried by VWIC (of two ports for future expansion), I'm wondering what VWIC sho...

I have a situation in which a call comes in via h323 with enbloc dialing. I have no direct control on the originating GW.Calls is routed to BRI pots, but because of the above, sending complete IE is sent in setup and call fails. I wanted the audio to...

i am using a AS5300 universal gateway how we can block the DID number to be displaying in the destination side.

Hello,I have been having trouble applying the "service-policy output" command to the pvc of an ATM sub-interface and I am running out of ideas and was wondering if anyone could recommend anything or has encountered this problem before. I've applied ...

I need to upgrade/replace phone model on ccm 4.2, somthing like 100 x C7905 is going to be replaced with 100 x C7940, but all other phone settings must survive transition.What is the simplest/easiest method ? Except obvious - retyping it all manualy....

How do you do that ?

Hi, I wonder if anyone could give me some light regarding the following In one site I have a 2811 and in the other site I have a 2811 with a PIX506E. Both routers are running CallManager Express with IOS versions: c2800nm-adventerprisek9-mz.124-4.XC4...

Hi All;I have five phones that belong to specific division in our company. they are all using "button 2o21,22,23,24,25" which is shared overlay ephone-dn. Is there any built-in call reporting in CME that shows number of inbound or outbound calls and ...